Exambible offers free demo for 300 075 ciptv2 exam. "CIPTV2 Implementing Cisco IP Telephony and Video, Part 2", also known as 300 075 vce exam, is a Cisco Certification. This set of posts, Passing the Cisco cisco 300 075 exam, will help you answer those questions. The cisco 300 075 Questions & Answers covers all the knowledge points of the real exam. 100% real Cisco 300 075 pdf exams and revised by experts!
♥♥ 2021 NEW RECOMMEND ♥♥
Free VCE & PDF File for Cisco 300-075 Real Exam (Full Version!)
★ Pass on Your First TRY ★ 100% Money Back Guarantee ★ Realistic Practice Exam Questions
Free Instant Download NEW 300-075 Exam Dumps (PDF & VCE):
Available on:
http://www.surepassexam.com/300-075-exam-dumps.html
P.S. Realistic 300-075 forum are available on Google Drive, GET MORE: https://drive.google.com/open?id=1bM34MPZHJhwuG5bvDsAvoAwjKkgB_mmF
New Cisco 300-075 Exam Dumps Collection (Question 9 - Question 18)
New Questions 9
When configuring intercluster URI dialing, an engineer gets the error message u201cLocal cluster cannot connect to the ILS networku201d. Which three reasons for this error are true? (Choose three.)
A. The SIP route patterns have not been properly configured.
B. The Tomcat certificates do not match.
C. The Cisco Unified Resource Identifier service needs a restart.
D. The ILS authentication password does not match.
E. The cluster ID does not match.
F. One cluster is using TLS certificate, and the other is using Password.
Answer: B,D,F
New Questions 10
Which two configurable options are available to enable Early Offer for calls over a Cisco Unified Communications Manager SIP trunk? (Choose two.)
A. Early Offer support for voice and video calls Mandatory (insert MTP if needed)
B. Media Termination Point Required
C. Use Trusted Relay Point
D. Accept Audio Codec Preferences in Received Offer
E. No Media Termination Point Required
Answer: A,B
New Questions 11
Which two statements regarding IPv4 Static NAT address 209.165.200.230 has been configured on a VCS Expressway are true? (Choose two.)
A. The Advanced Networking or Dual Network Interfaces option key has been installed.
B. VCS rewrites the Layer 3 source address of outbound SIP and H.323 packets to 209.165.200.230.
C. VCS applies 209.165.200.230 to outbound SIP and H.323 payload messages.
D. With static NAT enabled on the LAN2 interface, VCS applies 209.165.200.230 to outbound H.323 and SIP payload traffic exiting the LAN1 interface.
Answer: A,C
New Questions 12
You want to perform Media Gateway Control Protocol gateway maintenance. For this purpose, you disable Media Control Gateway Protocol gateway using the no mgcp command. After you perform the maintenance, you want to enable the Media Control Gateway Protocol gateway.
Which command should you use?
A. enable mgcp
B. mgcp
C. mgcp enable
D. mgcp yes
E. activate mgcp
F. mgcp active
Answer: B
New Questions 13
The administrator at Company X is getting user reports of inconsistent quality on video calls between endpoints registered to Cisco Unified Communications Manager. The administrator runs a wire trace while a video call is taking place and sees that the packets are not set to AF41 for desktop video as they should be.
Where should the administrator look next to confirm that the correct DSCP markings are being set?
A. on the MGCP router at the edge of both networks
B. the service parameters in the VCS Control
C. the QoS service parameter in Cisco Unified Communications Manager
D. on the actual Cisco phone itself because the DSCP setting is not part of its configuration
file downloaded at registration
E. The setting cannot be changed for video endpoints that are registered to Cisco Unified Communications Manager, but only when they are registered to the VCS Control.
Answer: C
New Questions 14
Scenario:
There are two call control systems in this item.
The Cisco UCM is controlling the DX650, the Cisco Jabber for Windows Client, and the 9971 Video IP Phone.
The Cisco VCS and TMS control the Cisco TelePresence MCU, and the Cisco Jabber TelePresence for Windows.
DP:
Locations:
CSS:
SRST:
SRST-BR2-Config:
BR2 Config:
SRSTPSTNCall:
After adding SRST functionality the SRST does not work. After reviewing the exhibits, which of the following reasons could be causing this failure?
A. Device Pool cannot be default.
B. The Cisco UCM is pointing to the wrong IPv4 address of the BR router.
C. The router does not support SRST.
D. The SRST enabled router is not configured correctly.
Answer: A
New Questions 15
When video endpoints register with Cisco Unified Communications Manager, where are DSCP values configured?
A. in Unified CM, under Enterprise Parameters Configuration
B. in Unified CM, under Device > Device Settings > Device Defaults
C. in Unified CM, under Service Parameters > Cisco CallManager Service > Cluster-wide Parameters
D. DSCP parameters are always configured on each individual video endpoint.
Answer: C
New Questions 16
Which device must be responsible for properly making network traffic when a cisco ip phone is connected to a cisco switch?
A. core layer switch
B. access layer switch
C. branch router
D. Cisco IP phono
Answer: B
New Questions 17
In which two locations can you verify that a phone has a standby Cisco Unified communications manager? (Choose two)
A. phone webpage
B. RTMT
C. Cisco Unified Serviceability
D. phone menu
Answer: A,D
New Questions 18
Refer to the exhibit.
If an IP phone in San Jose roams to New York, which two IP phone settings will be modified by Device Mobility so that the phone can place and receive calls in New York? (Choose two.)
A. The physical locations are not different, so the configuration of the phone is not modified.
B. The physical locations are different, so the roaming-sensitive parameters of the roaming device pool are applied.
C. The device mobility groups are the same, so the Device Mobility-related settings are applied in addition to the roaming-sensitive parameters.
D. The Device Mobility information is associated with one or more device pools other than the home device pool of the phone, so one of the associated device pools is chosen based on a round-robin load-sharing algorithm.
E. The Device Mobility information is associated with the home device pool of the phone, so the phone is considered to be in its home location. Device Mobility will reconfigure the roaming-sensitive settings of the phone.
Answer: B,C
Recommend!! Get the Realistic 300-075 dumps in VCE and PDF From Examcollection, Welcome to download: http://www.examcollectionuk.com/300-075-vce-download.html (New 245 Q&As Version)
