Master the 300 320 arch pdf Designing Cisco Network Service Architectures content and be ready for exam day success quickly with this Pass4sure aerospatiale alenia atr 42 300 320 practice. We guarantee it!We make it a reality and give you real atr 42 300 320 questions in our Cisco 300 320 dumps braindumps.Latest 100% VALID Cisco 300 320 arch Exam Questions Dumps at below page. You can use our Cisco ccdp 300 320 braindumps and pass your exam.
♥♥ 2021 NEW RECOMMEND ♥♥
Free VCE & PDF File for Cisco 300-320 Real Exam (Full Version!)
★ Pass on Your First TRY ★ 100% Money Back Guarantee ★ Realistic Practice Exam Questions
Free Instant Download NEW 300-320 Exam Dumps (PDF & VCE):
Available on:
http://www.surepassexam.com/300-320-exam-dumps.html
Q111. Which of the following facts must be considered when designing for IP telephony within an Enterprise Campus network?
A. Because the IP phone is a three-port switch, IP telephony extends the network edge, impacting the Distribution layer.
B. Video and voice are alike in being bursty and bandwidth intensive, and thus impose requirements to be lossless, and have minimized delay and jitter.
C. IP phones have no voice and data VLAN separation, so security policies must be based on upper layer traffic characteristics.
D. Though multi-VLAN access ports are set to dot1q and carry more than two VLANs they are not trunk ports.
Answer: D
Q112. Which IPv6 transition model should be utilized when two or more independent transition mechanisms are required?
A. tunneling
B. dual stack
C. service block
D. hybrid
E. manual
Answer: D
Q113. Which type of connectivity is required for VPLS?
A. full mesh
B. partial mesh
C. star
D. bus
E. ring
Answer: A
Q114. Which four Cisco proprietary Spanning Tree Protocol enhancements are supported with rapid per-VLAN Spanning-Tree plus? (Choose four.)
A. PortFast
B. UplinkFast
C. loop guard
D. root guard
E. BPDU guard
F. BackboneFast
Answer: A,C,D,E
Q115. What are two advantages of a L2 looped data center design model? (Choose two.)
A. promotes Layer 2 high availability
B. prevents VLAN propagation
C. allows sharing of service modules
D. eliminates the use of STP
E. improves data transfer speeds
Answer: A,C
Q116. Which two of these are characteristics of multicast routing? (Choose two.)
A. multicast routing uses RPF.
B. multicast routing is connectionless.
C. In multicast routing, the source of a packet is known.
D. When network topologies change, multicast distribution trees are not rebuilt, but use the original path
E. Multicast routing is much like unicast routing, with the only difference being that it has a a group of receivers rather than just one destination
Answer: A,C
Q117. Which router type injects external LSAs into the OSPF database using either other routing protocols or static routes?
A. backbone router
B. ABR
C. internal router
D. designated router
E. ASBR
Answer: E
Q118. A campus network in a switch block design requires redundant distribution switches, load sharing across uplinks, a loop-free topology, and only one gateway IP address per VLAN. Which switching technology meets all of the requirements?
A. HSRP
B. VSS
C. Spanning Tree Protocol
D. EtherChannel
Answer: B
Q119. A company's virtualization team wants to transfer control of network switching and policy
management for VMware virtual servers to the networking team. What Cisco network virtualization solution should be implemented?
A. Unified Computing System
B. Nexus distributed virtual switch
C. virtual network agent
D. Nexus unified fabric switch
Answer: B
Q120. Which protocol is used in an in-band network and why?
A. UDP, because it is connectionless
B. SSH, because the username and password are encrypted
C. Telnet, because the username and password are sent in clear
D. MSDP, because it uses TCP as its transport protocol
Answer: B
