Master the ccdp arch 300 320 Designing Cisco Network Service Architectures content and be ready for exam day success quickly with this Exambible 300 320 arch pdf latest exam. We guarantee it!We make it a reality and give you real ccdp arch 300 320 pdf questions in our Cisco 300 320 dumps braindumps.Latest 100% VALID Cisco ccdp arch 300 320 Exam Questions Dumps at below page. You can use our Cisco ccdp 300 320 braindumps and pass your exam.
♥♥ 2021 NEW RECOMMEND ♥♥
Free VCE & PDF File for Cisco 300-320 Real Exam (Full Version!)
★ Pass on Your First TRY ★ 100% Money Back Guarantee ★ Realistic Practice Exam Questions
Free Instant Download NEW 300-320 Exam Dumps (PDF & VCE):
Available on:
http://www.surepassexam.com/300-320-exam-dumps.html
Q1. What are two advantages of using Cisco FEX devices in the data center design? (Choose two.)
A. Traffic-forwarding decisions are made by the Cisco FEX device.
B. Cisco FEX devices must be upgraded when the parent switch is upgraded.
C. Traffic-forwarding decisions are made by the parent switch, resulting in easier troubleshooting and centralized management.
D. Cisco FEX devices do not have to be upgraded when the parent switch is upgraded, resulting in cost savings.
E. Cisco FEX devices can be part of two different VDCs.
Answer: C,D
Q2. Which two of these are correct regarding the recommended practice for distribution layer design? (Choose two.)
A. use a redundant link to the core
B. use a Layer 2 link between distribution switches
C. never use a redundant link to the core because of convergence issues
D. use a Layer 3 link between distribution switches with route summarization
E. use a Layer 3 link between distribution switches without route summarization
Answer: A,D
Q3. Which protocol is best when there are circuit connections with two different ISPs in a multihoming scenario?
A. VRRP
B. BGP
C. IPsec
D. SSL
Answer: B
Q4. Which two WAN technologies support IEEE 802.1Q, site-to-site connectivity, and point-to-point connectivity between two offices? (Choose two.)
A. Ethernet over MPLS
B. VPLS
C. Layer 3 MPLS
D. DSL
E. cable
Answer: A,B
Q5. Voice and video-conferencing applications that support multistreaming use which protocol?
A. TCP
B. RTP
C. Multipath TCP
D. SCTP
Answer: D
Q6. Which configuration represents resiliency at the hardware and software layers?
A. multiple connections and FHRP
B. HSRP and GLBP
C. redundant supervisor and power supplies
D. dual uplinks and switches
Answer: A
Q7. Which statement best describes Cisco OTV internal interfaces?
A. They are Layer 2 interfaces that are configured as either access or trunk interfaces on the switch.
B. They are interfaces that perform Layer 3 forwarding with aggregation switches.
C. They are the interfaces that connect to the ISP.
D. They are tunnel interfaces that are configured with GRE encapsulation.
Answer: A
Q8. Which two design recommendations are most appropriate when OSPF is the data center
core routing protocol? (Choose two.)
A. Never use passive interfaces.
B. Use NSSA areas from the core down.
C. Use totally stub areas to stop type 3 LSAs.
D. Use the lowest Ethernet interface IP address as the router ID.
E. Manipulate the reference bandwidth.
Answer: B,E
Q9. Which option is used as a top-of-rack device that is managed by its parent device, providing ease of management?
A. Cisco Nexus 2000
B. Cisco Nexus 5000
C. Cisco Nexus 7000
D. Cisco Nexus 9000
Answer: A
Q10. Recently, the WAN links between the headquarters and branch offices have been slow under peak congestion, yet multiple alternate WAN paths exist that are not always congested. What technology can allow traffic to be routed in a more informed manner to utilize transport characteristics such as delay, loss, or link load?
A. performance routing
B. static routing
C. on demand routing
D. policy based routing
Answer: A
