It is impossible to pass Cisco 300-815 exam without any help in the short term. Come to Exambible soon and find the most advanced, correct and guaranteed Cisco 300-815 practice questions. You will get a surprising result by our Updated Implementing Cisco Advanced Call Control and Mobility Services (CLACCM) practice guides.
Cisco 300-815 Free Dumps Questions Online, Read and Test Now.
NEW QUESTION 1
Configure Call Queuing in Cisco Unified Communications Manager. Where do you set the maximum number of callers in the queue?
- A. in the telephony service configuration
- B. in the queuing configuration
- C. in Cisco Unified CM Enterprise Parameters
- D. in Cisco Unified CM Service Parameters
Answer: B
NEW QUESTION 2
When locations-based Call Admission Control denies the call, which two masks can AAR apply when routing the call through the PSTN? (Choose two.)
- A. AAR destination mask
- B. called party transform mask
- C. external phone number mask
- D. +E.164 alternate number mask
- E. enterrise alternate number mask
Answer: AC
NEW QUESTION 3
A support engineer is troubleshooting a voice network. When conducting a search for call setup details related to calling search space issues, which trace files should be investigated?
- A. CallManager traces
- B. CTI Manager traces
- C. Cisco IP Manager Assistant
- D. Call logs
Answer: A
NEW QUESTION 4
A company has an SRST gateway running an IOS XE image. The company plans to enable the IPv6 addressing companywide. To enable the IPv6 in a unified SRST gateway to support SIP phones, what are two supported supplementary features for an IPv6 fallback scenario? (Choose two.)
- A. three-way conference
- B. secure SIP lines
- C. T.38 fax relay
- D. transcoding
- E. SIP trunk
Answer: AC
NEW QUESTION 5
Refer to the exhibit. How many maximum hops can an ILS updarte traverse?
- A. 3
- B. 6
- C. 9
- D. 12
Answer: A
NEW QUESTION 6
Which two types of distribution algorithm are within a line group? (Choose two.)
- A. random
- B. circular
- C. highest preference
- D. top down
- E. bottom up
Answer: BD
NEW QUESTION 7
Where on Cisco Unified Communications Manager do you configure the standard local route group for a group of devices?
- A. System > Location Info
- B. Call Routing > Route/Hunt > Local Route Group Names
- C. System > Device Pool
- D. Call Routing > Emergency Location > Emergency Location (ELIN) Groups
Answer: B
NEW QUESTION 8
After configuring a Cisco CallManager Express with Cisco Unity Express, inbound calls from the PSTN SIP trunk receive a ring tone for 20 seconds and then a busy signal instead of voicemail. Which configuration fixes this problem?
- A. Router(config)# voice service voipRouter(conf-voi-serv)#allow-connections h323 to h323
- B. Router(config)#dial-peer voice 2 voipRouter(config-dial-peer)#no vad
- C. Router(config)# voice service voipRouter(conf-voi-serv)#allow-connections voice-mail mod
- D. Router(config)# voice service voipRouter(conf-voi-serv)#no supplementary-service sip moved-temporarily
Answer: A
NEW QUESTION 9
A user reports that when they attempt to log out from the Cisco Extension Mobility service by pressing the Services button, they cannot log out. What is the most likely cause of this issue?
- A. The Cisco Extension Mobility service has not been configured on the phone.
- B. There might be a significant delay between the button being pressed and the Cisco Extension Mobility service recognizing i
- C. It would be best to check network latency.
- D. The user device profile has not been assigned to the user.
- E. The user device profile is not subscribed to the Cisco Extension Mobility service.
Answer: D
NEW QUESTION 10
What is the relationship between partition, time schedule, and time period in Time-of-Day routing in Cisco Unified Communications Manager?
- A. A partition can have multiple time schedules assigne
- B. A time schedule contains one or more time periods.
- C. A partition can have one time schedule assigne
- D. A time schedule contains one or more time periods.
- E. A partition can have multiple time schedules assigne
- F. A time schedule contains only one time period.
- G. A partition can have one time schedule assigne
- H. A time schedule contains only one time period.
Answer: A
NEW QUESTION 11
The Cisco Unified Communications Manager Dialed Number Analyzer allows analysis of calls from which two devices? (Choose two.)
- A. translation patterns
- B. device pools
- C. CTI ports
- D. CTI route points
- E. IP phones
Answer: CE
NEW QUESTION 12
A user in location X dials an extension at location Y. The call travels through a QoS-enabled WAN network, but the user experiences choppy or clipped audio. What is the cause of this issue?
- A. missing Call Admission Control
- B. codec mismatch
- C. ptime mismatch
- D. phone class of service issue
Answer: B
NEW QUESTION 13
What are the elements for Device Mobility configuration?
- A. physical location, device pool, and Device Mobility group
- B. device pool, Device Mobility group, and region
- C. physical locatio
- D. Device Mobility group, and region
- E. device pool, Device Mobility group, and Cisco IP phone
Answer: A
NEW QUESTION 14
In Cisco Unified Communications Manager globalized call routing is implemented and must confirm that it is correctly implemented without making a call. Which tool do you use for verification?
- A. Dialed Number Analyzer
- B. Real-Time Monitoring Tool
- C. SDI trace
- D. SDL trace
Answer: A
NEW QUESTION 15
Which action is correct with respect to toll fraud prevention configuration in the Cisco Unified Communications Manager Express?
- A. Configure Direct Inward Dial for Incoming ISDN Calls with overlap dialing.
- B. Configure IP Address Trusted Authentication for Incoming VoIP Calls.
- C. Configure the command no ip address trusted authenticate under “voice service voip”.
- D. Enable Secondary Dial tone on Analog and Digital FXO Ports.
Answer: B
NEW QUESTION 16
Which top-level IOS command is needed to begin the configuration of a Cisco Unified Communications Manager Express gateway to enable phones to be registered via SIP?
- A. allow-connections sip to sip
- B. voice service voip
- C. voice register global
- D. voice register dn
Answer: C
NEW QUESTION 17
Refer to the exhibit. Within the North American Numbering Plan, gateways located in Ottawa, Canada and marked as “YOW” are assigned to the Calling Party Transformation CSS NANP_CgPTP, which contains partition NANP_calling_xforms. What is the calling-party number and the numbering type if the calling user +1613-555-1234 dials the number?
- A. calling number 613-555-1234 and numbering type “subscriber”
- B. calling number 011-1-613-555-1234 and numbering type “subscriber”
- C. calling number 011613-555-1234 and numbering type “international”
- D. calling number 613-555-1234 and numbering type “national”
Answer: D
NEW QUESTION 18
Refer to the exhibit. Calls incoming from the provider are not working through newly set up Cisco Unified Border Element. Provider engineers get the 404 Not Found SIP message. Incoming calls are coming from the provider with called number “222333444” and Cisco Unified Communications Manager is expecting the called number to be delivered as “444333222”. The administrator already verified that the IP address of the Cisco Unified CM is set up correctly and there are no dial peers configured other than those shown in the exhibit. Which action must the administrator take to fix the issue?
- A. Change the destination-pattern on the outgoing dial peer to match “444333222”.
- B. Set up translation-profile on the incoming dial peer to match incoming traffic.
- C. Create specific matching for “222333444” on the incoming dial peer.
- D. Fix the voice translation-rule to match specifically number “222333444” and change it to “444333222”.
Answer: B
NEW QUESTION 19
The administrator of ABC company is troubleshooting a one-way audio issue for a call that uses H.323 protocol (slow-start mode). The administrator requests that you provide the IP and port information of the Real-Time Transport Protocol traffic that had the one-way audio call.
You gather the H.225 and H.245 messages for one of the one-way audio calls. Where can you find the RTP IP and port information for both sides? (Note: This call flow has not invoked any media resources like MTP or transcoders).
- A. H.245 Terminal Capability Set
- B. H.245 Open Logical Channel
- C. H.225 Connect
- D. H.245 Open Logical Channel Ack
Answer: B
NEW QUESTION 20
A user reports when they press the services key they do not receive a user ID and password prompt to assign the phone extension. Which action resolves the issue?
- A. Create the default device profiles for all phone models that are used.
- B. Subscribe the phone to the Cisco Extension Mobility service.
- C. Create the end user and associate it to the device profile.
- D. Assign the extension as a mobile extension.
Answer: B
NEW QUESTION 21
What is a component of Cisco Unified Mobility?
- A. Unified IVR
- B. Mobile Connect
- C. Smart Client Support
- D. Single Number Connect
Answer: B
NEW QUESTION 22
......
Recommend!! Get the Full 300-815 dumps in VCE and PDF From Allfreedumps.com, Welcome to Download: https://www.allfreedumps.com/300-815-dumps.html (New 0 Q&As Version)
