Our pass rate is high to 98.9% and the similarity percentage between our 352-001 study guide and real exam is 90% based on our seven-year educating experience. Do you want achievements in the Cisco 352-001 exam in just one try? I am currently studying for the Cisco 352-001 exam. Latest Cisco 352-001 Test exam practice questions and answers, Try Cisco 352-001 Brain Dumps First.
♥♥ 2021 NEW RECOMMEND ♥♥
Free VCE & PDF File for Cisco 352-001 Real Exam (Full Version!)
★ Pass on Your First TRY ★ 100% Money Back Guarantee ★ Realistic Practice Exam Questions
Free Instant Download NEW 352-001 Exam Dumps (PDF & VCE):
Available on:
http://www.surepassexam.com/352-001-exam-dumps.html
Q81. On a VoIP solution design, which option shows one-way latency, packet loss, and jitter measurements that ensure acceptable voice quality?
A. Latency: 110 ms Packet loss: 1% Jitter: 40 ms
B. Latency: 130 ms Packet loss: 0.5% Jitter: 30 ms
C. Latency: 150 ms Packet loss: 1.25% Jitter: 20 ms
D. Latency: 170 ms Packet loss: 0.75% Jitter: 10 ms
Answer: B
Q82. Refer to the exhibit.
You are planning the design of an encrypted WAN. IP packets will be transferred over encrypted GRE tunnels between routers B and C. The packet size is limited to a maximum of 1500 bytes inside the WAN between routers B and C. If endpoint 1 tries to send 1500-byte IP packets to endpoint 2, in what three ways will the network design handle the fragmentation in three different possible network configurations? (Choose three.)
A. When router B fragments packets after the encryption, router C must reassemble these fragmented packets.
B. When router B fragments packets before the encryption, router C must reassemble these fragmented packets.
C. When router B fragments packets after the encryption, the endpoint 2 must reassemble these fragmented packets.
D. When router B fragments packets before the encryption, endpoint 2 must reassemble these fragmented packets.
E. When router A fragments packets, router C must reassemble these fragmented packets.
F. When router A fragments packets, endpoint 2 must reassemble these fragmented packets.
Answer: ADF
Q83. A network designer is redesigning an enterprise campus network to ensure that Ethernet switches proactively attempt to reconnect after a fiber cut. In the design, they will have to address areas where fiber cuts exist on campus from past troubleshooting, where a single fiber is disconnected in the fiber pair, leading to looping. Which feature could be implemented in the design to allow the Spanning Tree Protocol on the switches to be protected?
A. loop guard
B. UniDirectional Link Detection
C. UniDirectional Link Detection aggressive mode
D. root guard
Answer: C
Q84. For a storage area network design, which technology allows a switch to support multiple Fibre Channel IDs per fabric port?
A. N-Port Identifier Virtualization
B. Inter-Virtual Storage Area Network Routing
C. Zoning
D. Fabric Port Trunking
E. Node Port Virtualization
F. Expansion Port Trunking
Answer: A
Q85. Refer to the exhibit.
After this new OSPF design with per-packet load balancing was implemented, Host A reported that large file downloads from Server A became slow and sometimes failed. The operations team discovered that packets are arriving out of order on R1. Which cost-conscious redesign action will fix the issue?
A. Upgrade all links to 10 Gbps.
B. Add an IP SLA probe on R1 and R4.
C. Adjust the OSPF auto-cost reference bandwidth on R4.
D. Adjust the OSPF auto-cost reference bandwidth on all routers.
Answer: D
Q86. You are evaluating convergence characteristics of various interior gateway protocols for a new network design. Which technology allows link-state routing protocols to calculate paths to destination prefixes that are functionally similar to feasible successors in Enhanced Interior Gateway Routing Protocol?
A. Incremental Shortest Path First
B. Cisco Multiprotocol Label Switching Traffic Engineering Fast Reroute
C. Loop-Free Alternate Fast Reroute
D. partial route calculation
E. Fast-Flooding
Answer: C
Q87. A Service Provider network designer is considering the use of the G.8032 Ethernet Ring Protection mechanism in order to provide resiliency in the network. Which three concepts will be supported with the implementation G.8032? (Choose three.)
A. Ring Protection Link (RPL)
B. Ring Automatic Protection Switching (R-APS)
C. Multi-Router Automatic Protection Switching (MR-APS)
D. Automatic Protection Switching (APS) Channel
Answer: ABD
Q88. You are tasked to design a QoS policy for a service provider so they can include it in the design of their MPLS core network. If the design must support an MPLS network with six classes, and CEs will be managed by the service provider, which QoS policy should be recommended?
A. map DSCP bits into the Exp field
B. map IP precedence bits into the DSCP field
C. map flow-label bits into the Exp field
D. map IP CoS bits into the IP Precedence field
E. map IP ToS bits into the Exp field
Answer: A
Q89. You are tasked with implementing a 1000-phone remote access solution, where phones will traverse a WAN edge router. Assuming all of the following features are supported in a hardware-assisted manner, which of the following will have the most detrimental impact on the delay of the packet?
A. encryption
B. stateful firewall
C. MPLS encapsulation
D. GRE encapsulation
Answer: A
Q90. A network designer wants to improve a company network design due to multiple network crashes. Which technology would allow for the restore of a network connection without informing the Layer 3 protocol?
A. Bidirectional Forwarding Detection
B. automatic protection switching
C. UniDirectional Link Detection
D. Ethernet OAM
Answer: B
