It is impossible to pass Cisco 352-001 exam without any help in the short term. Come to Pass4sure soon and find the most advanced, correct and guaranteed Cisco 352-001 practice questions. You will get a surprising result by our Replace CCDE Written Exam practice guides.
♥♥ 2021 NEW RECOMMEND ♥♥
Free VCE & PDF File for Cisco 352-001 Real Exam (Full Version!)
★ Pass on Your First TRY ★ 100% Money Back Guarantee ★ Realistic Practice Exam Questions
Free Instant Download NEW 352-001 Exam Dumps (PDF & VCE):
Available on:
http://www.surepassexam.com/352-001-exam-dumps.html
Q111. In which two ways is a network design improved by the inclusion of IP Event Dampening? (Choose two.)
A. reduces processing load
B. provides sub-second convergence
C. improves network stability
D. prevents routing loops
E. quickly detects network failures
Answer: AC
Q112. Which mechanism should be added to a network design to identify unidirectional Spanning Tree Protocol failures through BPDU loss?
A. UDLD
B. loop guard
C. BPDU guard?
D. root guard
Answer: B
Q113. In a network design using carrier Ethernet, which three mechanisms can be used to improve Layer 2 down detection and thereby reduce routing convergence time? (Choose three.)
A. BFD
B. Ethernet port debounce timers
C. link-state tracking
D. object tracking
E. fast IGP hello
Answer: ADE
Q114. Refer to the exhibit.
Acme Corporation hired you as a network designer to upgrade their network so that it supports IPv4 and IPv6 multicast. Which two protocols are needed on the LAN switch? (Choose two.)
A. PIM sparse mode
B. IGMP snooping
C. PIM snooping
D. Source Specific Multicast
E. MLD snooping
Answer: BE
Q115. Refer to the exhibit.
In this design, which technology would provide for the best use of resources to provide end-to-end Layer 2 connectivity?
A. MSTP
B. PAgP
C. Multichassis EtherChannel
D. LACP
Answer: C
Q116. Refer to the exhibit.
Company A is running a single-area OSPF, and Company B is running RIP as the IGP with no overlapping IP address spaces. Company A has just acquired Company B and both networks must be merged. Which three design components are recommended to guarantee connectivity and redundancy between the two networks? (Choose three.)
A. Enable mutual redistribution between OSPF and RIP on one border router.
B. Enable mutual redistribution between OSPF and RIP on Router A and Router B using route tags.
C. Increase the administrative distance to 130 for the OSPF external prefixes on Router A and Router B.
D. Implement an ACL on Router A and Router B to prevent OSPF external routes from being installed in the OSPF database.
E. Filter external routes on Router A and Router B based on route tags.
Answer: BCE
Q117. Refer to the exhibit.
A service provider would like to use Ethernet OAM to detect end-to-end connectivity failures between SP-SW1 and SP-SW2. In which two of these ways can you design this solution? (Choose two.)
A. Enable Y.1731 Connectivity Fault Management on the SP switches.
B. E-LMI PDUs must be forwarded over VPLS.
C. Cisco Discovery Protocol PDUs must be forwarded over the VPLS.
D. Use upward maintenance endpoints on the SP switches.
E. Enable IEEE 802.1ag Connectivity Fault Management on the SP switches.
Answer: DE
Q118. What are two functions of an NSSA in an OSPF network design? (Choose two.)
A. It overcomes issues with suboptimal routing when there are multiple exit points from the area.
B. It allows ASBRs to inject external routing information into the area.
C. An ASBR advertises Type 7 LSAs into the area.
D. An ABR advertises Type 7 LSAs into the area.
E. It uses opaque LSAs.
Answer: BC
Q119. You are deploying a nationwide intranet solution for a company with 4 data centers and 400 remote branches connected via a provider-based solution. As part of the network design, you must ensure efficient content distribution of training material to remote sites. Which two VPN technologies leverage replication in the network core and provide for efficient bandwidth optimization? (Choose two.)
A. VPLS
B. EoMPLS
C. MPLS Layer 3 VPN
D. GRE
E. GET VPN
Answer: CE
Q120. Your company will attach to a new Gigabit Ethernet-based wide area network from the local service provider for remote connectivity. Each connection will have a 150 Mb/s committed information rate. For the design of this new service, which QoS mechanism should be used to ensure low packet loss toward the service provider network?
A. shaping
B. policing
C. CBWFQ
D. RED
Answer: A
