♥♥ 2021 NEW RECOMMEND ♥♥
Free VCE & PDF File for CompTIA N10-006 Real Exam (Full Version!)
★ Pass on Your First TRY ★ 100% Money Back Guarantee ★ Realistic Practice Exam Questions
Free Instant Download NEW N10-006 Exam Dumps (PDF & VCE):
Available on:
http://www.surepassexam.com/N10-006-exam-dumps.html
Q11. Which of the following protocols must be implemented in order for two switches to share VLAN information?
A. VTP
B. MPLS
C. STP
D. PPTP
Answer: A
Q12. An administrator has a virtualization environment that includes a vSAN and iSCSI switching. Which of the following actions could the administrator take to improve the performance of data transfers over iSCSI switches?
A. The administrator should configure the switch ports to auto-negotiate the proper Ethernet settings.
B. The administrator should configure each vSAN participant to have its own VLAN.
C. The administrator should connect the iSCSI switches to each other over inter-switch links (ISL).
D. The administrator should set the MTU to 9000 on the each of the participants in the vSAN.
Answer: D
Q13. A technician is configuring a managed switch and needs to enable 802.3af. Which of the following should the technician enable?
A. PoE
B. Port bonding
C. VLAN
D. Trunking
Answer: A
Q14. A company has had several virus infections over the past few months. The infections were caused by vulnerabilities in the application versions that are being used. Which of the following should an administrator implement to prevent future outbreaks?
A. Host-based intrusion detection systems
B. Acceptable use policies
C. Incident response team
D. Patch management
Answer: D
Q15. A network engineer is dispatched to an employee office to troubleshoot an issue with the employee's laptop. The employee is unable to connect to local and remote resources. The network engineer flips the laptop's wireless switch on to resolve the issue. At which of the following layers of the OSI model was the issue resolved?
A. Layer 1
B. Layer 2
C. Layer 3
D. Layer 4
E. Layer 7
Answer: A
Q16. When troubleshooting a network problem, browsing through the log of a switch, it is discovered that multiple frames contain errors. In which of the following layers does the problem reside? (Select TWO).
A. Layer 2
B. Layer 3
C. Layer 5
D. Transport layer
E. Data link
F. Physical layer
Answer: AE
Q17. A technician has finished configuring AAA on a new network device. However, the technician is unable to log into the device with LDAP credentials but is able to do so with a local user account. Which of the following is the MOST likely reason for the problem?
A. Username is misspelled is the device configuration file
B. IDS is blocking RADIUS
C. Shared secret key is mismatched
D. Group policy has not propagated to the device
Answer: C
Q18. A network technician is troubleshooting a problem at a remote site. It has been determined that the connection from router A to router B is down. The technician at the remote site re-terminates the CAT5 cable that connects the two routers as a straight through cable. The cable is then tested and is plugged into the correct interface. Which of the following would be the result of this action?
A. The normal amount of errors and the connection problem has been resolved.
B. The interface status will indicate that the port is administratively down.
C. The traffic will flow, but with excessive errors.
D. The interface status will show line protocol down.
Answer: D
Q19. An administrator only has telnet access to a remote workstation. Which of the following utilities will identify if the workstation uses DHCP?
A. tracert
B. ping
C. dig
D. ipconfig
E. netstat
Answer: D
Q20. A technician, Joe, needs to troubleshoot a recently installed NIC. He decides to ping the local loopback address. Which of the following is a valid IPv4 loopback address?
A. 10.0.0.1
B. 127.0.0.1
C. 172.16.1.1
D. 192.168.1.1
Answer: B
