we provide Pinpoint Fortinet NSE7_EFW latest exam which are the best for clearing NSE7_EFW test, and to get certified by Fortinet NSE7 Enterprise Firewall - FortiOS 5.4. The NSE7_EFW Questions & Answers covers all the knowledge points of the real NSE7_EFW exam. Crack your Fortinet NSE7_EFW Exam with latest dumps, guaranteed!
NEW QUESTION 1
In which of the following states is a given session categorized as ephemeral? (Choose two.)
- A. A TCP session waiting to complete the three-way handshake.
- B. A TCP session waiting for FIN ACK.
- C. A UDP session with packets sent and received.
- D. A UDP session with only one packet receive
Answer: BC
NEW QUESTION 2
View the exhibit, which contains the partial output of an IKE real-time debug, and then answer the
question below.
ike 0: comes 10.0.0.2:500->10.0.0.1:500, ifindex=7....
ike 0: IKEv1 exchange=Aggressive id=baf47d0988e9237f/2f405ef3952f6fda len=430 ike 0: in
BAF47D0988E9237F2F405EF3952F6FDA0110040000000000000001AE0400003C00000001000000010 00000300101000
ike 0:RemoteSite:4: initiator: aggressive mode get 1st response...
ike 0:RemoteSite:4: VID RFC 3947 4A131c81070358455C5728F20E95452F ike 0:RemoteSite:4: VID DPD AFCAD71368A1F1C96B8696FC77570100
ike 0:RemoteSite:4: VID FORTIGATE 8299031757A36082C6A621DE000502D7
ike 0:RemoteSite:4: peer is FortiGate/Fortios (v5 b727)
ike 0:RemoteSite:4: VID FRAGMENTATION 4048B7D56EBCE88525E7DE7F00D6C2D3
ike 0:RemoteSite:4: VID FRAGMENTATION 4048B7D56EBCE88525E7DE7F00D6C2D3C0000000
ike 0:RemoteSite:4: received peer identifier FQDN ‘remore’ ike 0:RemoteSite:4: negotiation result
ike 0:RemoteSite:4: proposal id = 1:
ike 0:RemoteSite:4: protocol id = ISAKMP: ike 0:RemoteSite:4: trans_id = KEY_IKE. ike 0:RemoteSite:4: encapsulation = IKE/none
ike 0:RemoteSite:4: type=OAKLEY_ENCRYPT_ALG, val=AES_CBC, key –len=128 ike 0:RemoteSite:4: type=OAKLEY_HASH_ALG, val=SHA.
ike 0:RemoteSite:4: type-AUTH_METHOD, val=PRESHARED_KEY. ike 0:RemoteSite:4: type=OAKLEY_GROUP, val=MODP1024.
ike 0:RemoteSite:4: ISAKMP SA lifetime=86400
ike 0:RemoteSite:4: ISAKMP SA baf47d0988e9237f/2f405ef3952f6fda key 16:
B25B6C9384D8BDB24E3DA3DC90CF5E73
ike 0:RemoteSite:4: PSK authentication succeeded ike 0:RemoteSite:4: authentication OK
ike 0:RemoteSite:4: add INITIAL-CONTACT ike 0:RemoteSite:4: enc
BAF47D0988E9237F405EF3952F6FDA081004010000000000000080140000181F2E48BFD8E9D603F
ike 0:RemoteSite:4: out BAF47D0988E9237F405EF3952F6FDA08100401000000000000008C2E3FC9BA061816A396F009A12
ike 0:RemoteSite:4: sent IKE msg (agg_i2send): 10.0.0.1:500-10.0.0.2:500, len=140, id=baf47d0988e9237f/2
ike 0:RemoteSite:4: established IKE SA baf47d0988e9237f/2f405ef3952f6fda Which statements about this debug output are correct? (Choose two.)
- A. The remote gateway IP address is 10.0.0.1.
- B. It shows a phase 1 negotiation.
- C. The negotiation is using AES128 encryption with CBC hash.
- D. The initiator has provided remote as its IPsec peer I
Answer: BD
NEW QUESTION 3
Examine the output from the 'diagnose debug authd fsso list' command; then answer the question below.
# diagnose debug authd fsso list —FSSO logons-IP: 192.168.3.1 User: STUDENT Groups: TRAININGAD/USERS Workstation: INTERNAL2. TRAINING. LAB The IP address 192.168.3.1 is NOT the one used by the workstation INTERNAL2. TRAINING. LAB.
What should the administrator check?
- A. The IP address recorded in the logon event for the user STUDENT.
- B. The DNS name resolution for the workstation name INTERNAL2. TRAININ
- C. LAB.
- D. The source IP address of the traffic arriving to the FortiGate from the workstation INTERNAL2. TRAININ
- E. LAB.
- F. The reserve DNS lookup forthe IP address 192.168.3.1.
Answer: C
NEW QUESTION 4
An administrator added the following Ipsec VPN to a FortiGate configuration: configvpn ipsec phasel -interface edit "RemoteSite" set type dynamic set interface "portl" set mode main
set psksecret ENC LCVkCiK2E2PhVUzZe next
end
config vpn ipsec phase2-interface edit "RemoteSite"
set phasel name "RemoteSite" set proposal 3des-sha256
next end
However, the phase 1 negotiation is failing. The administrator executed the IKF real time debug while attempting the Ipsec connection. The output is shown in the exhibit.
What is causing the IPsec problem in the phase 1 ?
- A. The incoming IPsec connection is matching the wrong VPN configuration
- B. The phrase-1 mode must be changed to aggressive
- C. The pre-shared key is wrong
- D. NAT-T settings do not match
Answer: C
NEW QUESTION 5
View the exhibit, which contains a session entry, and then answer the question below.
Which statement is correct regarding this session?
- A. It is an ICMP session from 10.1.10.10 to 10.200.1.1.
- B. It is an ICMP session from 10.1.10.10 to 10.200.5.1.
- C. It is a TCP session in ESTABLISHED state from 10.1.10.10 to 10.200.5.1.
- D. It is a TCP session in CLOSE_WAIT state from 10.1.10.10 to 10.200.1.1.
Answer: A
NEW QUESTION 6
Examine the following partial output from two system debug commands; then answer the question below.
Which of the following statements are true regarding the above outputs? (Choose two.)
- A. The unit is running a 32-bit FortiOS
- B. The unit is in kernel conserve mode
- C. The Cached value is always the Active value plus the Inactive value
- D. Kernel indirectly accesses the low memory (LowTotal) through memory paging
Answer: AC
NEW QUESTION 7
Which of the following statements are true about FortiManager when it is deployed as a local FDS? (Choose two.)
- A. Caches available firmware updates for unmanaged devices.
- B. Can be configured as an update server, or a rating server, but not both.
- C. Supports rating requests from both managed and unmanaged devices.
- D. Provides VM license validation service
Answer: AD
NEW QUESTION 8
View the exhibit, which contains the output of get sys ha status, and then answer the question below.
Which statements are correct regarding the output? (Choose two.)
- A. The slave configuration is not synchronized with the master.
- B. The HA management IP is 169.254.0.2.
- C. Master is selected because it is the only device in the cluster.
- D. port 7 is used the HA heartbeat on all devices in the cluste
Answer: AC
NEW QUESTION 9
View the exhibit, which contains a screenshot of some phase-1 settings, and then answer the question below.
The VPN is up, and DPD packets are being exchanged between both IPsec gateways; however, traffic cannot pass through the tunnel. To diagnose, the administrator enters these CLI commands:
However, the IKE real time debug does not show any output. Why?
- A. The debug output shows phases 1 and 2 negotiations onl
- B. Once the tunnel is up, it does not show any more output.
- C. The log-filter setting was set incorrectl
- D. The VPN’s traffic does not match this filter.
- E. The debug shows only error message
- F. If there is no output, then the tunnel is operating normally.
- G. The debug output shows phase 1 negotiation onl
- H. After that, the administrator must enable the following real time debug: diagnose debug application ipsec -1.
Answer: D
NEW QUESTION 10
Which of the following conditions must be met for a static route to be active in the routing table? (Choose three.)
- A. The next-hop IP address is up.
- B. There is no other route, to the same destination, with a higher distance.
- C. The link health monitor (if configured) is up.
- D. The next-hop IP address belongs to one of the outgoing interface subnets.
- E. The outgoing interface is u
Answer: ABE
NEW QUESTION 11
Examine the output of the ‘diagnose sys session list expectation’ command shown in the exhibit; than answer the question below.
Which statement is true regarding the session in the exhibit?
- A. It was created by the FortiGate kernel to allow push updates from FotiGuard.
- B. It is for management traffic terminating at the FortiGate.
- C. It is for traffic originated from the FortiGate.
- D. It was created by a session helper or AL
Answer: A
NEW QUESTION 12
An LDAP user cannot authenticate against a FortiGate device. Examine the real time debug output shown in the exhibit when the user attempted the authentication; then answer the question below.
- A. User student is not found in the LDAP server.
- B. User student is using a wrong password.
- C. The FortiGate has been configured with the wrong password for the LDAP administrator.
- D. The FortiGate has been configured with the wrong authentication schem
Answer: A
NEW QUESTION 13
View the exhibit, which contains the output of a real-time debug, and then answer the question below.
Which of the following statements is true regarding this output? (Choose two.)
- A. This web request was inspected using the root web filter profile.
- B. FortiGate found the requested URL in its local cache.
- C. The requested URL belongs to category ID 52.
- D. The web request was allowed by FortiGat
Answer: BC
NEW QUESTION 14
Which statements about bulk configuration changes using FortiManager CLI scripts are correct? (Choose two.)
- A. When executed on the Policy Package, ADOM database, changes are applied directly to the managed FortiGate.
- B. When executed on the Device Database, you must use the installation wizard to apply the changes to the managed FortiGate.
- C. When executed on the All FortiGate in ADOM, changes are automatically installed without creating a new revision history.
- D. When executed on the Remote FortiGate directly, administrators do not have the option to review the changes prior to installation.
Answer: AD
NEW QUESTION 15
When using the SSL certificate inspection method for HTTPS traffic, how does FortiGate filter web requests when the browser client does not provide the server name indication (SNI)?
- A. FortiGate uses the Issued To: field in the server’s certificate.
- B. FortiGate switches to the full SSL inspection method to decrypt the data.
- C. FortiGate blocks the request without any further inspection.
- D. FortiGate uses the requested URL from the user’s web browse
Answer: D
NEW QUESTION 16
A FortiGate device has the following LDAP configuration:
The administrator executed the ‘dsquery’ command in the Windows LDAp server 10.0.1.10, and got the following output:
>dsquery user –samid administrator
“CN=Administrator, CN=Users, DC=trainingAD, DC=training, DC=lab” Based on the output, what FortiGate LDAP setting is configured incorrectly?
- A. cnid.
- B. username.
- C. password.
- D. d
Answer: A
NEW QUESTION 17
What configuration changes can reduce the memory utilization in a FortiGate? (Choose two.)
- A. Reduce the session time to live.
- B. Increase the TCP session timers.
- C. Increase the FortiGuard cache time to live.
- D. Reduce the maximum file size to inspec
Answer: AD
NEW QUESTION 18
View the exhibit, which contains the output of a web diagnose command, and then answer the question below.
Which one of the following statements explains why the cache statistics are all zeros?
- A. The administrator has reallocated the cache memory to a separate process.
- B. There are no users making web requests.
- C. The FortiGuard web filter cache is disabled in the FortiGate’s configuration.
- D. FortiGate is using a flow-based web filter and the cache applies only to proxy-based inspectio
Answer: D
NEW QUESTION 19
Examine the following partial outputs from two routing debug commands; then answer the question below:
Why the default route using port2 is not displayed in the output of the second command?
- A. It has a lower priority than the default route using port1.
- B. It has a higher priority than the default route using port1.
- C. It has a higher distance than the default route using port1.
- D. It is disabled in the FortiGate configuratio
Answer: A
NEW QUESTION 20
A FortiGate is rebooting unexpectedly without any apparent reason. What troubleshooting tools could an administrator use to get more information about the problem? (Choose two.)
- A. Firewall monitor.
- B. Policy monitor.
- C. Logs.
- D. Crashlog
Answer: CD
NEW QUESTION 21
View these partial outputs from two routing debug commands:
Which outbound interface will FortiGate use to route web traffic from internal users to the Internet?
- A. Both port1 and port2
- B. port3
- C. port1
- D. port2
Answer: C
NEW QUESTION 22
......
Thanks for reading the newest NSE7_EFW exam dumps! We recommend you to try the PREMIUM Simply pass NSE7_EFW dumps in VCE and PDF here: https://www.simply-pass.com/Fortinet-exam/NSE7_EFW-dumps.html (88 Q&As Dumps)