Your success in Fortinet NSE8_810 is our sole target and we develop all our NSE8_810 braindumps in a way that facilitates the attainment of this target. Not only is our NSE8_810 study material the best you can find, it is also the most detailed and the most updated. NSE8_810 Practice Exams for Fortinet Fortinet Other Exam NSE8_810 are written to the highest standards of technical accuracy.
Check NSE8_810 free dumps before getting the full version:
NEW QUESTION 1
Exhibit
You configured an IPsec tunnel to a branch office. Now you want to make sure that the encryption of the tunnel is offloaded to hardware referring to the exhibit, which statement is true?
- A. Incoming and outgoing traffic is offloaded
- B. Outgoing traffic is offloaded, you cannot determine if incoming traffic is offloaded at this time.
- C. Traffic is not offloaded.
- D. Outgoing traffic is offloaded: incoming traffic not offloade
Answer: D
NEW QUESTION 2
A company has just deployed a new FortiMail in gateway mode. The administrator is asked to strengthen e-mail protection by applying the policies shown below.
- E-mails can only be accepted if a valid e-mail account exists.
- Only authenticated users can send e-mails out
Which two actions will satisfy the requirements? (Choose two. )
- A. Configure recipient address verification.
- B. Configure inbound recipient policies.
- C. Configure outbound recipient policies.
- D. Configure access control rule
Answer: AC
NEW QUESTION 3
A FortOS devices is used for termination of VPNs for number of remote spoke VPN units (designated group A spokes) using a phase 1 main mode dial-up tunnel using pre-shared. Your company recently acquired another organization. You are asked establish VPN correctively for the newly acquired organization's sites which new devices will be provisioned (designated Group B spokes). Both exiting (Group A) and new (Group B) spoke units are dynamically addressed. You are asked to ensure that spokes from the acquired organization (Group B) have different access permission than your existing VPN spokes (Group A).
Which two solutions meet the represents for the new spoke group? (Choose two.)
- A. implements a new phase 1 dial-up mode tunnel with preshared keys and XAut
- B. Use identity to filter traffic.
- C. Implement a new phase 1 dial-up main mode tunnel with a different pre-shared key than the Group A spoke
- D. Use standard policies to filter for the new dial-up tunnel
- E. Implement a new phase 1 dial-up main mode tunnel with certificate authenticatio
- F. Use standard policies to filter for the dial-up tunnel.
- G. Implement separate phase 1 dial-up aggressive mode tunnels with a distinct peer I
- H. Use standard policies to filter traffic for the new dial-up tunnel.
Answer: AB
NEW QUESTION 4
Exhibit
You need to apply the security feature below to the network shown in the exhibit.
-- high grade DDoS protection
-- Web security and load balacng for Server 1 and Server
-- Solution must be PCI DSS compliant'
-- enhanced security to DNS 1 and DNS 2 What are three solutio for the scenario?
- A. FortiWeb forVDOM-A
- B. FortDDoS between FG1 and FG2 and the Internet
- C. FortiADC for VDOM-A
- D. FortADC for VDoM-B
- E. FortiDDoS between FG1 and FG2 and VDOMs
Answer: D
NEW QUESTION 5
Exhibit
An administrator implements a multi-chassis Link aggregation (MCLAG) solution using two FortiSwitch 448Ds and one FortiGate 3700D.
As described in the topology shown in the exhibit. two Inks are connected to each FortiSwitch. what is required to implement this solution? (Choose two )
- A. a FortiGate with a hardware or a software switch
- B. an ICL link between both FortiSwitches
- C. a disabled FortiLink, split interface
- D. two Link aggregated (LAG) interfaces on the FortiGate side
Answer: AD
NEW QUESTION 6
Exhibit
When deploying a new FortiGate-VMX Security node, an administrator received the error message shown in the exhibit In this scenario, which statement is correct?
- A. The vCenter was not able locate the FortiGate-VMX's OVF file.
- B. The vCenter could not connect to the FortiGate Service Manager
- C. The NSX Manager was not able to connect on the FortiGate Service Manager's RestAPI service.
- D. The FortiGate Service Manager did not have the proper permission to register the FortiGate-VMX Servic
Answer: C
NEW QUESTION 7
You have deployed a FortiGate In NAT/Route mode as a secure as a web gateway with a few P-base authentication firewall policies. Your customer reports that some users now have different browsing permission =s from what is expected. All these users are browsing using internet Explorer through Desktop Connection to a Terminal Server. When you took at the Fortigate logs the username for the Terminal Server IP is not consistent.
Which action will correct this problem?
- A. Make sure Terminal Service is using the correct DNS ever.
- B. Configure FSSO Advanced with LDAP integration
- C. Change the FSSO polling mode to windows NetAPI
- D. Install the TSCitrix on the terminal server
Answer: C
NEW QUESTION 8
Exhibit
Referring to the exhibit, a FortiADC is load balancing IPV4 traffic between next-hop routers. The FortiADC does not know the IP addresses of the servers, Also the FortiADC is doing Layer 7 content inspection and modification.
In this scenario, which application delivery control is configured in the FortiADC?
- A. Layer 2
- B. Layer 3
- C. Laye.4
- D. Layer 7
Answer: D
NEW QUESTION 9
Exhibit
Your organization has a FortrGate cluster that is connected to two independent ISPs. You must configure the FortiGate failover for a single ISP failure to occur without disruption.
Referring to the exhibit, which two FortiGate BGP features would be used to accomplish this task' (Choose two.)
- A. Enable BFD
- B. Enable EBGP multipath
- C. Enable graceful restart
- D. Enable synchronization
Answer: BC
NEW QUESTION 10
Exhibit
You log into FortiManager, look at the Device Manager window and notice that one of you managed devices is not in normal status.
Referring to the exhibit, which two statements correctly describe the affected device's status and result? (Choose two.)
- A. The device configuration was changed on the local FoitiGate side onl
- B. auto-update is disabled.
- C. The device configuration was changed on both the local FortiGate side and the FortiManager side, auto-update is disabled.
- D. The changed configuration on the FortiGate wrt remain the next time that the device configuration is pushed from ForbManager.
- E. The changed configuration on the FortiGate will be overwritten in favor of what is on the FortiMAnager the next time that the device configuration is pushed.
Answer: BD
NEW QUESTION 11
Exhibit
You have configured an HA cluster with Two FortiGates You want to make sore that you are able to manage the individual duster members using ports3.
Referring to the exhibit, what are two ways to accomplish this task? (Choose two.)
- A. Disable the sync feature on porl3: then configure specific IPs for ports on both cluster members.
- B. Configure port3 to be a dedicated HA management interface, then configure specific IPs for port3 on both cluster members.
- C. Create a management VDOM and Disable the HA synchronization for this VDOM, assign ports to this VDOM, then configure specific IPs for ports on both cluster member.
- D. Allow administrative access in the HA heartbeat interface
Answer: BC
NEW QUESTION 12
You cannot the FortiGales default gateway 10.10.10 .1 from the FortiGate CLI. The FortiGate interface facing the default gateway is wan 1 and its IP address 10.10 .10 K74 During the troubleshooting, tests, you confirmed that you can plug other IP addresses in the 10.10.10. 0/24 subnet from the FortiGAte CLI without packets lost.
Which two CLI commands will help you to troubleshoot this problem? (Choose two.)
- A. diagnose ip arp list
- B. diag aniffer packet wan1 'arp and host 10.10.1O.1'
- C. diagnose hardware deviceinfo nice wan1
- D. diagnose debug flow filter addt 10.10.10.1
- E. diagnose debug flow trace trace 10
Answer: AD
NEW QUESTION 13
Exhibit
[MISSING]
You configure AV and Web filtering for your outgoing internet connection.
You later notice that not all Web session are being inspection and you start troubleshooting the problem. Referring to the exhibit, what would cause this problem?
- A. The Web session is using QUIC which a not inspected by the FortiGate
- B. These are problem with the connection to the Web filter servers, therefore the Web session cannot be categorized.
- C. The SSL inspection options are not set to inspection
- D. Web filtering is not licensed, therefore no inspection occur
Answer: A
NEW QUESTION 14
Exhibit
Referring to the exhibit, which command-line option for deep inspection SSL would have the FortiGAte re=sign all untrusted self-signed certificates with the trusted Fortinet_CA_SSl certificate?
- A. allow
- B. block
- C. ignore
- D. inspect
Answer: D
NEW QUESTION 15
Exhibit
The exhibit shows a topology where a FortiGate is two VDOMS, root and vd-vlasn. The root VDCM provides SSL-VPN access, where the users authenticated by a FortiAuthenticatator.
The vd-lan VDOM provids internal access to a Web server. For the remote users to access the internal web server, there are a few requirements, which are shown below.
--At traffic must come from the SSI-VPN
--The vd-lan VDOM only allows authenticated traffic to the Web server.
-- Users must only authenticate once, using the SSL-VPN portal.
-- SSL-VPN uses RADIUS-based authentication.
referring to the exhibit, and the requirement describe above, which two statements are true? (Choose two.)
- A. vd-lan authentication messages from root using FSSO.
- B. vd-lan connects to Fort authenticator as a regular FSSO client.
- C. root is configured for FSSO while vd-lan is configuration for RSSO.
- D. root sends “RADIUS Accounting Messages" to FortiAuthenticato
Answer: AC
NEW QUESTION 16
Your client wants to use a central RADIUS server for management authentication when connecting to the FortiGate GUL and provide different levels of access for different types of employees.
Which three actions required providing the requested functionality? (Choose three.)
- A. Enable radius-vdom-override in the CLI.
- B. Create a wildcard administrator on the FortGate
- C. Enable occprofile-override in the CLI.
- D. Set the RADIUS authencation type to MS-CHApV2.
- E. Create multiple administrator profiles with matching RADIUS VSA
Answer: CDE
NEW QUESTION 17
A customer wants to enable SYN Rood mitigation in a FortiDDoS device. The FortiDDoS must reply with one SYN/ACK packet per SYN packet ftom a new source IP address. Which SYN packet from a new source IP address. Which SYN flood mitigation mode must the customer use?
- A. SYN cookie
- B. SYN/ACK cookie
- C. ACK cookie
- D. SYN retransmission
Answer: A
NEW QUESTION 18
Exhibit
A customer gas just finished their Azure deployment to ensure a Web application behind a FortiWeb. Now they want to add components to protect against advance threats (zero day attacks), centrally the entire environment, and centrally monitor Fortinet and non-Fortinet products.
Which Fortinet will standby these requirements?
- A. Use FotiAnalyzer lor monitor in Azure, FortiSlEM for managemnet, and FortiSandbox for zero day attacks on their local network.
- B. Use Fortianalyzer for monitor Azure, FortiSiEM for management, and FortiGate has zero day attacks on their local network.
- C. Use FortiManager for management in Azure, FortSIEM for monitoring and FcrtiSandbox for zero day attacks on their local network.
- D. Use FortiSIEM for management Azure, FortiManager for management, and FortrGate for zero day attacks on their local network.
Answer: A
NEW QUESTION 19
Exhibit
You created a custom health-check for your FortiWeb deployment. Referring to the output shown in the exhibit, which statement is true?
- A. The FortiWeb must receive an RST packet from the server.
- B. The FortiWeb must receive an HTTP 200 response code from the server.
- C. The FortiWeb must receive an ICMP Echo Request from the server.
- D. The FortiWeb must match the hash value of the page index htm
Answer: B
NEW QUESTION 20
Exhibit
The exhibit shows the steps for creating a URL rewrite policy on a FortWet-Which statement represents the purpose of this policy?
- A. The policy redirects all HTTP URLs to HTTPS.
- B. The policy redirects all HTTPS URLs to HTTP.
- C. The policy redirects only HTTPS URLs containing the ˆ/ (. *) S string to HTTP.
- D. The pokey redirects only HTTP URLs containing theˆ/ ( .*)S string to HTTP
Answer: A
NEW QUESTION 21
......
P.S. Certifytools now are offering 100% pass ensure NSE8_810 dumps! All NSE8_810 exam questions have been updated with correct answers: https://www.certifytools.com/NSE8_810-exam.html (60 New Questions)
