Our This experts dedicate in order to keeping the Cisco Cisco practice questions as well as answers up-to-date. You should preserve visit Ucertify.com regularly to ensure if there are some changes in each of our Cisco 300-320 exam products. Along with download the most recent Cisco 300-320 practice questions timely. You will be well prepared for your Cisco Cisco real exam using our Cisco Pdf simulation supplies.
♥♥ 2021 NEW RECOMMEND ♥♥
Free VCE & PDF File for Cisco 300-320 Real Exam (Full Version!)
★ Pass on Your First TRY ★ 100% Money Back Guarantee ★ Realistic Practice Exam Questions
Free Instant Download NEW 300-320 Exam Dumps (PDF & VCE):
Available on:
http://www.surepassexam.com/300-320-exam-dumps.html
2021 Mar 300-320 test engine
Q151. A network design engineer has been asked to reduce the size of the SPT on an IS-IS broadcast network. Which option should the engineer recommend to accomplish this task?
A. Configure the links as point-to-multipoint.
B. Configure QoS in all links.
C. Configure a new NET address.
D. Configure the links as point-to-point.
Answer: D
Q152. What are two benefits of using 6to4 as an IPv6 transition method? (Choose two.)
A. 6to4 tunnels allow isolated IPv6 domains to be remotely connected over IPv4 networks.
B. Manual configuration (scalability) is easier.
C. Point-to-multipoint automatic tunneling (automatic 6to4) is available.
D. An infinite number of address spaces are allocated to an IPv6 subnet.
E. Globally unique IPv4 addresses are not required.
Answer: A,C
Q153. In a collapsed core design, which three benefits are provided by a second-generation Cisco MDS director? (Choose three.)
A. a higher fan-out ratio
B. fully redundant switches
C. 100 percent port efficiency
D. all ISLs contained within a single chassis
E. higher latency and throughput than a core-edge design switch
Answer: B,C,D
Q154. Which VRF component ensures control plane separation between the different Layer 3 VPNs?
A. FIB
B. routing protocol instance
C. RIB
D. a subset of the router interfaces
Answer: B
Q155. Which part of the Layer 3 header is used to identify a flow in NetFlow but it is not used for NBAR?
A. source port
B. ToS
C. protocol type
D. source IP
Answer: B
Update 300-320 practice test:
Q156. What is one reason to implement Control Plane Policing?
A. allow OSPF routing protocol to advertise routes
B. protect the network device route processor from getting overloaded by rate limiting the incoming control plane packets
C. allow network devices to generate and receive packets
D. protect the data plane packets
Answer: B
Q157. Which Cisco feature can be run on a Cisco router that terminates a WAN connection, to gather and provide WAN circuit information that helps switchover to dynamically back up the WAN circuit?
A. Cisco Express Forwarding
B. IP SLA
C. passive interface
D. traffic shaping
Answer: B
Q158. Which command can you enter to inject BGP routes into an IGP?
A. redistribute bgp
B. redistribute static
C. redistribute static subnet
D. default-information originate
Answer: A
Q159. What are two advantages of using Cisco FEX devices in the data center design? (Choose two.)
A. Traffic-forwarding decisions are made by the Cisco FEX device.
B. Cisco FEX devices must be upgraded when the parent switch is upgraded.
C. Traffic-forwarding decisions are made by the parent switch, resulting in easier troubleshooting and centralized management.
D. Cisco FEX devices do not have to be upgraded when the parent switch is upgraded, resulting in cost savings.
E. Cisco FEX devices can be part of two different VDCs.
Answer: C,D
Q160. Which of the following is true concerning best design practices at the switched Access layer of the traditional layer2 Enterprise Campus Network?
A. Cisco NSF with SSO and redundant supervisors has the most impact on the campus in the Access layer
B. Provide host-level redundancy by connecting each end device to 2 separate Access switches
C. Offer default gateway redundancy by using dual connections from Access switches to redundant Distribution layer switches using a FHRP
D. Include a link between two Access switches to support summarization of routing information from the Access to the Distribution layer
Answer: A
