Master the ccdp arch 300 320 Designing Cisco Network Service Architectures content and be ready for exam day success quickly with this Exambible 300 320 arch pdf latest exam. We guarantee it!We make it a reality and give you real ccdp arch 300 320 pdf questions in our Cisco 300 320 dumps braindumps.Latest 100% VALID Cisco ccdp arch 300 320 Exam Questions Dumps at below page. You can use our Cisco ccdp 300 320 braindumps and pass your exam.
♥♥ 2021 NEW RECOMMEND ♥♥
Free VCE & PDF File for Cisco 300-320 Real Exam (Full Version!)
★ Pass on Your First TRY ★ 100% Money Back Guarantee ★ Realistic Practice Exam Questions
Free Instant Download NEW 300-320 Exam Dumps (PDF & VCE):
Available on:
http://www.surepassexam.com/300-320-exam-dumps.html
Q41. DRAG DROP
Answer:
Q42. Which protocol should be configured if a network administrator wants to configure multiple
physical gateways to participate simultaneously in packet forwarding?
A. HSRP
B. VRRP
C. GLBP
D. VTP
Answer: C
Q43. Which option describes why duplicate IP addresses reside on the same network in Cisco network design?
A. HSRP designed network
B. using Cisco ACE in active/passive mode
C. VRRP designed network
D. running multiple routing protocols
Answer: B
Q44. Which of these statements is correct regarding Stateful Switchover and Cisco Nonstop Forwarding?
A. Utilizing Cisco NSF in Layer 2 environments can reduce outages to one to three seconds.
B. Utilizing SSO in Layer 3 environments can reduce outages to one to three seconds.
C. Distribution switches are single points of failure causing outages for the end devices.
D. Utilizing Cisco NSF and SSO in a Layer 2 environment can reduce outages to less than one second.
E. NSF and SSO with redundant supervisors have the most impact on outages at the access layer.
Answer: E
Q45. Which option is the Cisco recommendation for data oversubscription for access ports on the access-to-distribution uplink?
A. 4 to 1
B. 20 to 1
C. 16 to 1
D. 10 to 1
Answer: B
Q46. Which technology is an example of the need for a designer to clearly define features and desired performance when designing advanced WAN services with a service provider?
A. FHRP to remote branches
B. Layer 3 MPLS VPNs secure routing
C. Control protocols (for example Spanning Tree Protocol) for a Layer 3 MPLS service
D. Intrusion prevention, QoS, and stateful firewall support network wide
Answer: B
Q47. A e-commerce network has many devices that often need to be upgraded on a regular basis. What technology will ensure IP packets continue to be forwarded even during a device failover?
A. stateful switchover
B. nonstop forwarding
C. route processor redundancy
D. optimized edge routing
E. enhanced object tracking
Answer: B
Q48. Which three options are recommended practices when configuring VTP? (Choose three.)
A. Set the switch to transparent mode.
B. Set the switch to server mode.
C. Enable VLAN pruning.
D. Disable VLAN pruning.
E. Specify a domain name.
F. Clear the domain name.
Answer: A,D,E
Q49. A network engineer must perform posture assessments on Cisco ASA remote access VPN clients and control their network access based on the results. What mode is the Cisco best practice NAC deployment design for this situation?
A. Layer 2 in-band real IP gateway mode
B. Layer 2 out-of-band real IP gateway mode
C. Layer 3 in-band virtual gateway mode
D. Layer 3 out-of-band virtual gateway mode
Answer: C
Q50. Which of the following is a recommended practice of a data center core?
A. Server-to-server traffic always remains in the core layer.
B. The core infrastructure should be in Layer 3.
C. Core layer should run BGP along with an IGP because iBGP has a lower administrative distance than any IGP.
D. The Cisco Express Forwarding hashing algorithm is the default, based on the IP address and Layer 4 port.
Answer: B
