we provide Virtual Cisco 300 320 arch pdf actual exam which are the best for clearing atr 42 300 320 test, and to get certified by Cisco ARCH Designing Cisco Network Service Architectures. The aerospatiale alenia atr 42 300 320 Questions & Answers covers all the knowledge points of the real 300 320 arch pdf exam. Crack your Cisco ccdp arch 300 320 pdf Exam with latest dumps, guaranteed!
♥♥ 2021 NEW RECOMMEND ♥♥
Free VCE & PDF File for Cisco 300-320 Real Exam (Full Version!)
★ Pass on Your First TRY ★ 100% Money Back Guarantee ★ Realistic Practice Exam Questions
Free Instant Download NEW 300-320 Exam Dumps (PDF & VCE):
Available on:
http://www.surepassexam.com/300-320-exam-dumps.html
P.S. Virtual 300-320 interactive bootcamp are available on Google Drive, GET MORE: https://drive.google.com/open?id=1E4HG0Hr1cICYvNNR27aTNE5kMrSvwapz
New Cisco 300-320 Exam Dumps Collection (Question 5 - Question 14)
New Questions 5
Which protocol is used in an in-band network and why?
A. UDP, because it is connectionless
B. SSH, because the username and password are encrypted
C. Telnet, because the username and password are sent in clear
D. MSDP, because it uses TCP as its transport protocol
Answer: B
New Questions 6
What data center network layer provides service module integration, Layer 2 domain definitions and default gateway redundancy?
A. core
B. aggregation
C. access
D. edge
Answer: B
New Questions 7
Which two key components are related to one firewall per ISP design option for e- commerce? (Choose two.)
A. It is a common approach to single-homing.
B. This approach is commonly used in large sites.
C. Any failure on an edge router results in a loss of session.
D. It has one NAT to two ISP-assigned blocks.
E. It is difficult to set up and administer.
Answer: C,D
New Questions 8
Which two of these correctly describe asymmetric routing and firewalls? (Choose two.)
A. only operational in routed mode
B. only operational in transparent mode
C. only eight interfaces can belong to an asymmetric routing group
D. operational in both failover and non-failover configurations
E. only operational when the firewall has been configured for failover
Answer: C,D
New Questions 9
here are 3 steps to confirm whether a range of IP addresses can be summarized. Which of the following is used in each of these 3 steps?
A. The first number in the contiguous block of addresses
B. The last number in the contiguous block of addresses
C. The size of the contiguous block of addresses
D. The subnet mask of the original network address
Answer: C
New Questions 10
Which three of these Metro service types map to E-Line (versus E-LAN) services that are defined by the Metro Ethernet Forum (MEF)? (Choose three.)
A. Ethernet Private Line
B. Ethernet Wire Service
C. Ethernet Relay Service
D. Ethernet Multipoint Service
E. Ethernet Relay Multipoint Service
Answer: A,B,C
New Questions 11
What is the maximum number of neighbors that a router should have in an OSPF area?
A. 5
B. 30
C. 50
D. 60
Answer: D
New Questions 12
EIGRP uses which algorithm to build a routing table?
A. Dijkstra's algorithm
B. Floyd-Warshall algorithm
C. Diffusing Update Algorithm
D. Johnson's algorithm
Answer: C
New Questions 13
Which feature must be configured for the VRRP-enabled router to regain the master VRRP status upon
recovery from a failure?
A. priority
B. authentication
C. pre-emption
D. Stateful Switchover
Answer: C
New Questions 14
Which statement about Fibre Channel communications is correct?
A. N_Port to N_Port connections use logical node connection points.
B. Flow control is only provided by QoS.
C. It must be implemented in an arbitrated loop.
D. Communication methods are similar to those of an Ethernet bus.
Answer: A
Explanation:
Fibre Channel supports a logical node connection point between node ports (N_ports). This is similar to TCP and UDP sockets.
100% Updated Cisco 300-320 Questions & Answers shared by Examcollectionplus, Get HERE: https://www.examcollectionplus.net/vce-300-320/ (New 482 Q&As)
