The Secret of 300-365 download

Pinpoint of 300-365 practice exam materials and vce for Cisco certification for IT specialist, Real Success Guaranteed with Updated 300-365 pdf dumps vce Materials. 100% PASS Deploying Cisco Wireless Enterprise Networks exam Today!

2021 Mar 300-365 exam price

Q31. A customer requires that an SSID is broadcasted to specific access points that use certain interfaces. Which feature can be used to achieve this goal? 

A. mobility groups 

B. flex-connect groups 

C. interface groups 

D. AP groups 

Answer:


Q32. A network engineer observes a spike in controller CPU overhead and overall network utilization after enabling multicast on a controller with 500 APs. What feature is necessary to correct the issue? 

A. controller IGMP snooping 

B. unicast AP Multicast Mode 

C. broadcast forwarding 

D. multicast AP Multicast Mode 

Answer:


Q33. A network engineer must configure a 5 GHz network to allow for the greatest density of radios possible with the least amount of co-channel interference. Which configuration best fulfills this requirement? 

A. Set 802.11 h Local Power constraint to 25 dBm. 

B. Set DCA to 20 MHz channels and enable Extended UNII-2 channels. 

C. Enable Event Driven RRM in 5 GHz with a sensitivity of High, n 

D. Configure TPC Power Threshold to -80 dBm and set interference Optimal Mode (TPCv2). 

Answer:


Avant-garde 300-365 actual exam:

Q34. A customer recently implemented WLC wireless multicast. Clients and connecting at the highest mandatory wireless rate of 24 Mbps and are receiving multicast traffic, but WLC cpu utilization and wired side network load has increased substantially. What three actions should the engineer take next to optimize the configuration? (Choose Three) 

A. verify that Global Multicast mode has been enabled 

B. verify that IGMP snooping is disabled on the wireless controller since the access points are handing IGMP messages from the clients. 

C. make sure the highest mandatory rate is set to 54 Mbps so that the multicast traffic has sufficient bandwidth 

D. verify Multicast Listener Discovery (MLD) v1 snooping has been enabled to keep track of and deliver IPv4 multicast flows 

E. change the wireless controller from Multicast-Unicastmodeto Multicast-Multicast mode and assign a multicast address in the 239.X.X.X/8 subnet 

F. verify that the L3 interfaces are configured for pirn sparse-dense-mode on the VLAN servicing the wireless access points as well as the wireless controller’s management VLAN 

Answer: A,B,E 


Q35. Which statement about when you configure FlexConnect APs and you want to set up Cisco Centralized Key Management fast roaming is true? 

A. FlexConnect groups are required for Cisco Centralized Key Management fast roaming to work with FlexConnect access points. 

B. APs that are in the same FlexConnect group but associated to different WLCs support Cisco Centralized Key Management. 

C. Cisco Centralized Key Management fast roaming among FlexConnect and non-FlexConnect access points is supported. 

D. The FlexConnect access point must be in standalone mode to support Cisco Centralized Key Management. 

Answer:


Q36. A network engineer for a college dormitory notices that student devices are filling up the SP-DB and are not allowing the shared wireless printers to be discovered. Which feature can be used to reserve space in the SP-DB for the printers? 

A. mDNS-AP 

B. LSS 

C. Priority MAC 

D. sso 

Answer:



see more 300-365 dumps