Act now and download your Cisco 300-365 test today! Do not waste time for the worthless Cisco 300-365 tutorials. Download Avant-garde Cisco Deploying Cisco Wireless Enterprise Networks exam with real questions and answers and begin to learn Cisco 300-365 with a classic professional.
♥♥ 2021 NEW RECOMMEND ♥♥
Free VCE & PDF File for Cisco 300-365 Real Exam (Full Version!)
★ Pass on Your First TRY ★ 100% Money Back Guarantee ★ Realistic Practice Exam Questions
Free Instant Download NEW 300-365 Exam Dumps (PDF & VCE):
Available on:
http://www.surepassexam.com/300-365-exam-dumps.html
Q1. CMX Facebook WiFi can allow access to the network before authentication. Which two of the following options are available? (Choose two)
A. Allow all the traffic before authentication and intercept HTTPs only.
B. Allow HTTP traffic only before authentication and block all the traffic.
C. Allow SNMP traffic only before authentication and block all the traffic.
D. Allow all the traffic before authentication and intercept HTTP only.
E. Allow HTTPs traffic only before authentication and block all other traffic.
Answer: B,D
Q2. You have a VoWLAN configured for platinum QoS, WMM, and CAC. IP phones for this VoWLAN include the Nokia and Cisco Unified Wireless IP Phones 7920G (pre-v2.0 firmware), 7921G, and 7925G. The Wireless IP Phones 7921G and 7925G work properly, but the Nokia and the Wireless IP Phones 7920G associate with the WLAN but cannot place calls. What is the issue?
A. The lowest mandatory speed in the WLAN is too high and needs to be reduced.
B. The Cisco Unified Wireless IP Phones 7920G and Nokia IP phones do not support TSPEC.
C. EDCA needs to be enabled on the WLAN.
D. HCCA needs to be enabled on the WLAN.
E. The reserved roaming bandwidth setting is set too low.
F. The expedited bandwidth setting needs to be enabled.
Answer: B
Q3. You have set up FlexConnect APs. For which scenario is Fast Roaming supported, providing the WLAN is mapped to the same VLAN and the client is roaming to an AP on the same Cisco WLC?
A. central switching with PMK (OKC) between different FlexConnect groups
B. local switching with Cisco Centralized Key Management within the same FlexConnect group
C. central switching with Cisco Centralized Key Management between different FlexConnect groups
D. local switching with PMKID within the same FlexConnect group
Answer: B
Q4. Which two options are limitations of using an AP as a workgroup bridge? (Choose two.)
A. Only factory-configured MAPs can support WGB mode.
B. MAPs that are configured in WGB mode do not answer S36 radio measurement requests.
C. A limited subset of Layer 2 security types are supported for wireless clients of a WGB.
D. There is a limit of 20 wired client devices.
E. Multiple VLANs are not supported for wireless clients.
Answer: B,D
Q5. An engineer must deploy FlexConnect APs to a site that typically has 300 ms latency to the WLC. Which typical operating mode must the engineer plan on for normal operations?
A. local authentication, local switching
B. central authentication, central switching
C. central authentication, local switching
D. connected mode
Answer: A
Q6. A network engineer is configuring QoS and sees a DSCP value of 40. To which CoS value will this be mapped?
A. 4
B. 3
C. 5
D. 2
E. 1
Answer: C
Q7. A customer requires that an SSID is broadcasted to specific access points that use certain interfaces. Which feature can be used to achieve this goal?
A. mobility groups
B. flex-connect groups
C. interface groups
D. AP groups
Answer: C
Q8. What is the default NMSP echo interval between a Mobility Services Engine and Wireless LAN Controller?
A. 30Seconds
B. 15 Seconds
C. 10 Seconds
D. 60 Seconds
Answer: B
Q9. An engineer wants to configure WebEx to adjust the precedence and override the QoS profile on the WLAN. Which configuration is needed to complete this task?
A. Change the AVC application WebEx-app-sharing to mark
B. Create an ACL for WebEx.
C. Change the WLAN reserved bandwidth for WebEx.
D. Create an AVC profile for WebEx marked with a lower DSCP value
Answer: A
Q10. A network engineer observes a spike in controller CPU overhead and overall network utilization after enabling multicast on a controller with 500 APs. What feature is necessary to correct the issue?
A. controller IGMP snooping
B. unicast AP Multicast Mode
C. broadcast forwarding
D. multicast AP Multicast Mode
Answer: B
