Facts about ccna 200 125 book

we provide Precise Cisco ccna routing and switching 200 125 exam topics which are the best for clearing 200 125 ccna pdf test, and to get certified by Cisco CCNA Cisco Certified Network Associate CCNA (v3.0). The 200 125 ccna Questions & Answers covers all the knowledge points of the real ccna 200 125 study guide exam. Crack your Cisco 200 125 cisco Exam with latest dumps, guaranteed!


♥♥ 2021 NEW RECOMMEND ♥♥

Free VCE & PDF File for Cisco 200-125 Real Exam (Full Version!)

★ Pass on Your First TRY ★ 100% Money Back Guarantee ★ Realistic Practice Exam Questions

Free Instant Download NEW 200-125 Exam Dumps (PDF & VCE):
Available on: http://www.surepassexam.com/200-125-exam-dumps.html

P.S. Precise 200-125 pack are available on Google Drive, GET MORE: https://drive.google.com/open?id=1IiiyEYVh7VGuzQjIt9B135ONv4m9W195


New Cisco 200-125 Exam Dumps Collection (Question 6 - Question 15)

Question No: 6

Refer to the exhibit.

IF R1 sends traffic to 192.168.101.45 the traffic is sent through which interface?

A. FastEthernet0/1

B. FastEthernet0/0

C. FastEthernet1/0

D. FastEthernet1/1

Answer: D


Question No: 7

When is a routing table entry identified as directly connected?

A. when the local router is in use as the network default gateway

B. when the network resides on a remote router that is physically connected to the local router

C. when an interface on the route is configure with an ip address and enabled

D. when the route is statically assigned to reach a specific network

Answer: C


Question No: 8

Which process is associated with spanning-tree convergence?

A. determining the path cost

B. electing designated ports

C. learning the sender bridge ID

D. assigning the port ID

Answer: B

Explanation:

Spanning Tree Protocol (STP) convergence (Layer 2 convergence) happens when bridges and switches have transitioned to either the forwarding or blocking state. When layer 2 is converged, Root Switch is elected andRoot Ports,Designated PortsandNon-Designated portsin all switches are selected. At Converged condition, theRoot Portsand the Designated ports are in forwarding state, and all other ports are in blocking state.


Question No: 9

Which three describe the reasons large OSPF networks use a hierarchical design? (Choose Three)

A. to speed up convergence

B. to reduce routing overhead

C. to lower costs by replacing routers with distribution layer switches.

D. to decrease latency by increasing bandwidth.

E. to confine network instability to single areas of the network.

F. to reduce the complexity of router configuration.

Answer: A,B,E


Question No: 10

Which RPVST+ port state is excluded from all STP operations?

A. learning

B. forwarding

C. blocking

D. disabled

Answer: D


Question No: 11

Which utility can you use to identify redundant or shadow rules ?

A. The ACL trace tool in Cisco APIC-EM.

B. The ACL analysis tool in Cisco APIC-EM.

C. The Cisco APIC-EM automation scheduler.

D. The Cisco IWAN application.

Answer: B


Question No: 12

What is one requirement for interfaces to run IPv6?

A. An IPv6 address must be configured on the interface.

B. An IPv4 address must be configured.

C. Stateless autoconfiguration must be enabled after enabling IPv6 on the interface.

D. IPv6 must be enabled with the ipv6 enable command in global configuration mode.

Answer: A

Explanation: To use IPv6 on your router, you must, at a minimum, enable the protocol and assign IPv6 addresses to your interfaces.


Question No: 13

which two options are requirements for configuring ripv2 for ipv4 network router ?(choose two)

A. connecting RIP to a WAN Interface

B. enabling auto route summarization

C. allowing unicast updates for RIP

D. enabling RIP on the router

E. enabling RIP authentication

Answer: C,D


Question No: 14

What type of MAC address is aged automatically by the switch?

A. Dynamic

B. Manual

C. Automatic

D. Static

Answer: A

Explanation: Reference:

http://www.cisco.com/c/en/us/td/docs/switches/datacenter/nexus5000/sw/configuration/guid e/cli/

CLIConfigurationGuide/MACAddress.htm


Question No: 15

Which tunneling mechanism embeds an IPv4 address within an IPv6 address?

A. Teredo

B. 6to4

C. 4to6

D. GRE

E. ISATAP

Answer: B

Explanation: ref :https://tools.ietf.org/html/rfc6052#section-2


100% Most up-to-date Cisco 200-125 Questions & Answers shared by Examcollectionplus, Get HERE: https://www.examcollectionplus.net/vce-200-125/ (New 889 Q&As)