It is impossible to pass Cisco 200-301 exam without any help in the short term. Come to Examcollection soon and find the most advanced, correct and guaranteed Cisco 200-301 practice questions. You will get a surprising result by our Update Cisco Certified Network Associate practice guides.
Online Cisco 200-301 free dumps demo Below:
NEW QUESTION 1
A client experiences slow throughput from a server that is directly connected to the core switch in a data center. A network engineer finds minimal latency on connections to the server, but data transfers are unreliable, and the output of the show Interfaces counters errors command shows a high FCS-Err count on the interface that is connected to the server. What is the cause of the throughput issue?
- A. high bandwidth usage
- B. a physical cable fault
- C. a speed mismatch
- D. a cable that is too long
Answer: B
NEW QUESTION 2
What criteria is used first during me root port selection process?
- A. local port ID
- B. lowest path cost to the root bridge
- C. lowest neighbor's bridge ID
- D. lowest neighbor's port ID
Answer: B
NEW QUESTION 3
How does a switch process a frame received on Fa0/1 with the destination MAC address of 0e38.7363.657b when the table is missing the address?
- A. lt drops the frame immediately.
- B. It forwards the frame back out of interface Fa0/1.
- C. It floods the frame to all interfaces except Fa0/1.
- D. It holds the frame until the MAC address timer expires and then drops the frame.
Answer: C
NEW QUESTION 4
Refer to the exhibit.
Which IPv6 configuration is required for R17 to successfully ping the WAN interface on R18?
A)
B)
C)
D)
- A. Option A
- B. Option B
- C. Option C
- D. Option D
Answer: B
Explanation:
ipv6 unicast-routing statement included (IPv6 is enabled on the router).Compared to the exhibit, Fa0/0 and Fa0/1 have correct configurations.The route to subnet 2001:db8:4::/64 points to R18’s Fa1/0 (correct next-hop).
NEW QUESTION 5
Refer to the exhibit Routers R1 and R2 have been configured with their respective LAN interfaces The two circuits are operational and reachable across WAN Which command set
establishes failover redundancy if the primary circuit goes down?
- A. Option A
- B. Option B
- C. Option C
- D. Option D
Answer: B
NEW QUESTION 6
With REST API, which standard HTTP header tells a server which media type is expected by the client?
- A. Accept-Encoding: gzi
- B. deflate
- C. Accept-Patch: text/example; charset=utf-8
- D. Content-Type: application/json; charset=utf-8
- E. Accept: application/json
Answer: D
Explanation:
Accept header is a way for a client to specify the media type of the response content it is expecting and Content-type is a way to specify the media type of request being sent from the client to the server.
http://www.java-allandsundry.com/2012/08/accept-header-vs-content-type- header.html#:~:text=Accept%20and%20Content%2Dtype%20are,the%20client%20to%20t he%20server
NEW QUESTION 7
What are network endpoints?
- A. act as routers to connect a user to the service prowler network
- B. a threat to the network if they are compromised
- C. support inter-VLAN connectivity
- D. enforce policies for campus-wide traffic going to the internet
Answer: B
NEW QUESTION 8
Which function is performed by the collapsed core layer in a two-tier architecture?
- A. enforcing routing policies
- B. marking interesting traffic for data polices
- C. attaching users to the edge of the network
- D. applying security policies
Answer: A
NEW QUESTION 9
Refer to the exhibit.
A network engineer configures the CCNA WLAN so that clients must authenticate hourly and to limit the number of simultaneous connections to the WLAN to Which two actions complete this configuration? (Choose two.)
- A. Enable the Enable Session Timeout option and set the value to 3600.
- B. Set the Maximum Allowed Clients value to 10.
- C. Enable the Client Exclusion option and set the value to 3600.
- D. Enable the Wi-Fi Direct Clients Policy option.
- E. Set the Maximum Allowed Clients Per AP Radio value to 10.
Answer: AB
NEW QUESTION 10
Refer to the exhibit.
A network engineer is configuring a WLAN to connect with the 172.16.10.0/24 network on VLAN 20. The engineer wants to limit the number of devices that connect to the WLAN on the USERWL SSID to 125. Which configuration must the engineer perform on the WLC?
- A. In the Management Software activation configuration, set the Clients value to 125.
- B. In the Controller IPv6 configuration, set the Throttle value to 125.
- C. In the WLAN configuration, set the Maximum Allowed Clients value to 125.
- D. In the Advanced configuration, set the DTIM value to 125.
Answer: C
NEW QUESTION 11
An engineer configures interface Gi1/0 on the company PE router to connect to an ISP Neighbor discovery is disabled
Which action is necessary to complete the configuration if the ISP uses third-party network devices?
- A. Enable LLDP globally
- B. Disable autonegotiation
- C. Disable Cisco Discovery Protocol on the interface
- D. Enable LLDP-MED on the ISP device
Answer: D
NEW QUESTION 12
Refer to the exhibit. Local access for R4 must be established and these requirements must be met:
• Only Telnet access is allowed.
• The enable password must be stored securely.
• The enable password must be applied in plain text.
• Full access to R4 must be permitted upon successful login. Which configuration script meets the requirements?
A)
B)
C)
D)
- A. Option A
- B. Option B
- C. Option C
- D. Option D
Answer: D
NEW QUESTION 13
Refer to the exhibit.
What two conclusions should be made about this configuration? (Choose two )
- A. The designated port is FastEthernet 2/1
- B. This is a root bridge
- C. The spanning-tree mode is Rapid PVST+
- D. The spanning-tree mode is PVST+
- E. The root port is FastEthernet 2/1
Answer: CE
Explanation:
An engineer is configuring data and voice services to pass through the same port. The designated switch interface fastethernet0/1 must transmit packets using the same priority for data when they are received from the access port of the IP phone. Which configuration must be used?
A)
B)
C)
D)
A. Option A
B. Option B
C. Option C
D. Option D
Answer: A
NEW QUESTION 14
Refer to the exhibit.
An administrator configures four switches for local authentication using passwords that are stored in a cryptographic hash. The four switches must also support SSH access for administrators to manage the network infrastructure. Which switch is configured correctly to meet these requirements?
- A. SW1
- B. SW2
- C. SW3
- D. SW4
Answer: C
NEW QUESTION 15
Which technology allows for multiple operating systems to be run on a single host computer?
- A. virtual routing and forwarding
- B. network port ID visualization
- C. virtual device contexts
- D. server visualization
Answer: D
NEW QUESTION 16
Which condition must be met before an NMS handles an SNMP trap from an agent?
- A. The NMS software must be loaded with the MIB associated with the trap.
- B. The NMS must be configured on the same router as the SNMP agent
- C. The NMS must receive a trap and an inform message from the SNMP agent within a configured interval
- D. The NMS must receive the same trap from two different SNMP agents to verify that it is reliable.
Answer: A
NEW QUESTION 17
......
Thanks for reading the newest 200-301 exam dumps! We recommend you to try the PREMIUM Thedumpscentre.com 200-301 dumps in VCE and PDF here: https://www.thedumpscentre.com/200-301-dumps/ (903 Q&As Dumps)
