Want to know Ucertify 200-301 Exam practice test features? Want to lear more about Cisco Cisco Certified Network Associate certification experience? Study Refined Cisco 200-301 answers to Update 200-301 questions at Ucertify. Gat a success with an absolute guarantee to pass Cisco 200-301 (Cisco Certified Network Associate) test on your first attempt.
Online 200-301 free questions and answers of New Version:
NEW QUESTION 1
Drag and drop the IPv4 network subnets from the left onto the correct usable host ranges on the right
- A. Mastered
- B. Not Mastered
Answer: A
Explanation: 
NEW QUESTION 2
Refer to Exhibit.
Which action do the switches take on the trunk link?
- A. The trunk does not form and the ports go into an err-disabled status.
- B. The trunk forms but the mismatched native VLANs are merged into a single broadcast domain.
- C. The trunk does not form, but VLAN 99 and VLAN 999 are allowed to traverse the link.
- D. The trunk forms but VLAN 99 and VLAN 999 are in a shutdown state.
Answer: C
NEW QUESTION 3
Which command enables a router to become a DHCP client?
- A. ip address dhcp
- B. ip helper-address
- C. ip dhcp pool
- D. ip dhcp client
Answer: A
NEW QUESTION 4
Refer to the exhibit.
Drag and drop the networking parameters from the left onto the correct values on the right. Check the answer below.
- A. Mastered
- B. Not Mastered
Answer: A
Explanation:
NEW QUESTION 5
Drag and drop the functions from the left onto the correct network components on the right
- A. Mastered
- B. Not Mastered
Answer: A
Explanation: 
NEW QUESTION 6
A network engineer must back up 20 network router configurations globally within a customer environment. Which protocol allows the engineer to perform this function using the Cisco IOS MIB?
- A. CDP
- B. SNMP
- C. SMTP
- D. ARP
Answer: C
NEW QUESTION 7
Which IPv6 address type provides communication between subnets and cannot route on the Internet?
- A. global unicast
- B. unique local
- C. link-local
- D. multicast
Answer: B
NEW QUESTION 8
A user configured OSPF and advertised the Gigabit Ethernet interface in OSPF By default, which type of OSPF network does this interface belong to?
- A. point-to-multipoint
- B. point-to-point
- C. broadcast
- D. nonbroadcast
Answer: B
NEW QUESTION 9
- A. Mastered
- B. Not Mastered
Answer: A
Explanation: 
NEW QUESTION 10
Refer to Exhibit.
An engineer is configuring the NEW York router to reach the Lo1 interface of the Atlanta router using interface Se0/0/0 as the primary path. Which two commands must be configured on the New York router so that it can reach the Lo1 interface of the Atlanta router via Washington when the link between New York and Atlanta goes down? (Choose two)
- A. ipv6 router 2000::1/128 2012::1
- B. ipv6 router 2000::1/128 2012::1 5
- C. ipv6 router 2000::1/128 2012::2
- D. ipv6 router 2000::1/128 2023::2 5
- E. ipv6 router 2000::1/128 2023::3 5
Answer: DE
NEW QUESTION 11
A user configured OSPF in a single area between two routers A serial interface connecting R1 and R2 is running encapsulation PPP By default which OSPF network type is seen on this interface when the user types show ip ospf interface on R1 or R2?
- A. port-to-multipoint
- B. broadcast
- C. point-to-point
- D. nonbroadcast
Answer: C
NEW QUESTION 12
Refer to the exhibit.
The New York router is configured with static routes pointing to the Atlanta and Washington sites. Which two tasks must be performed so that the Serial0/0/0 interfaces on the Atlanta and Washington routers can reach one another? (Choose two.)
- A. Configure the ipv6 route 2012::/126 2023::1 command on the Washington router
- B. Configure the ipv6 route 2023::/126 2012::1 command on the Atlanta router.
- C. Configure the Ipv6 route 2012::/126 s0/0/0 command on the Atlanta router
- D. Configure the ipv6 route 2023::/126 2012::2 command on the Atlanta router
- E. Configure the ipv6 route 2012::/126 2023::2 command on the Washington router
Answer: CE
NEW QUESTION 13
An engineer is asked to protect unused ports that are configured in the default VLAN on a switch. Which two steps will fulfill the request? (Choose two)
- A. Configure the ports in an EtherChannel.
- B. Administratively shut down the ports
- C. Configure the port type as access and place in VLAN 99
- D. Configure the ports as trunk ports
- E. Enable the Cisco Discovery Protocol
Answer: AD
NEW QUESTION 14
Which statement about Link Aggregation when implemented on a Cisco Wireless LAN Controller is true?
- A. To pass client traffic two or more ports must be configured.
- B. The EtherChannel must be configured in "mode active"
- C. When enabled the WLC bandwidth drops to 500 Mbps
- D. One functional physical port is needed to pass client traffic
Answer: C
NEW QUESTION 15
Which 802.11 frame type is association response?
- A. management
- B. protected frame
- C. control
- D. action
Answer: B
NEW QUESTION 16
Drag and drop the descriptions of file-transfer protocols from the left onto the correct protocols on the right.
- A. Mastered
- B. Not Mastered
Answer: A
Explanation: 
NEW QUESTION 17
When a floating static route is configured, which action ensures that the backup route is used when the primary route fails?
- A. The floating static route must have a higher administrative distance than the primary route so it is used as a backup
- B. The administrative distance must be higher on the primary route so that the backup route becomes secondary.
- C. The floating static route must have a lower administrative distance than the primary route so it is used as a backup
- D. The default-information originate command must be configured for the route to be installed into the routing table
Answer: A
NEW QUESTION 18
R1 has learned route 192.168.12.0/24 via IS-IS. OSPF, RIP. and Internal EIGRP Under normal operating conditions, which routing protocol is installed in the routing table?
- A. IS-IS
- B. RIP
- C. Internal EIGRP
- D. OSPF
Answer: C
NEW QUESTION 19
Which two encoding methods are supported by REST APIs? (Choose two)
- A. YAML
- B. JSON
- C. EBCDIC
- D. SGML
- E. XML
Answer: AE
NEW QUESTION 20
Refer to the exhibit.
With which metric was the route to host 172.16.0.202 learned?
- A. 110
- B. 38443
- C. 3184439
Answer: C
NEW QUESTION 21
Refer to the exhibit.
An engineer configured NAT translations and has verified that the configuration is correct. Which IP address is the source IP?
- A. 10.4.4.4
- B. 10.4.4.5
- C. 172.23.103.10
- D. 172.23.104.4
Answer: C
NEW QUESTION 22
Which two outcomes are predictable behaviors for HSRP? (Choose two)
- A. The two routers share a virtual IP address that is used as the default gateway for devices on the LAN.
- B. The two routers negotiate one router as the active router and the other as the standby router
- C. Each router has a different IP address both routers act as the default gateway on the LAN, and traffic is load balanced between them.D The two routers synchronize configurations to provide consistent packet forwarding
- D. The two routed share the same IP address, and default gateway traffic is load-balanced between them
Answer: AB
NEW QUESTION 23
Which network allows devices to communicate without the need to access the Internet?
- A. 1729.0.0/16
- B. 172.28.0.0/16
- C. 192.0.0.0/8
- D. 209.165.201.0/24
Answer: D
NEW QUESTION 24
What makes Cisco DNA Center different from traditional network management applications and their management of networks?
- A. It only supports auto-discovery of network elements in a greenfield deployment.
- B. It modular design allows someone to implement different versions to meet the specific needs of an organization
- C. IT abstracts policy from the actual device configuration
- D. It does not support high availability of management functions when operating in cluster mode
Answer: A
NEW QUESTION 25
......
P.S. Easily pass 200-301 Exam with 103 Q&As Dumpscollection Dumps & pdf Version, Welcome to Download the Newest Dumpscollection 200-301 Dumps: http://www.dumpscollection.net/dumps/200-301/ (103 New Questions)
