It is more faster and easier to pass the by using . Immediate access to the and find the same core area with professionally verified answers, then PASS your exam with a high score now.
Free demo questions for Cisco 300-370 Exam Dumps Below:
NEW QUESTION 1
Which visual cue accurately describes a characteristic of the zone of impact displayed in Cisco Prime Infrastructure?
- A. The closer the cirlce is to blue, the more localized the impact is.
- B. The smaller the circle, the more localized the impact is.
- C. The larger the circle, the more severe the impact is.
- D. The more translucent the circle is, the more localized the impact i
Answer: B
NEW QUESTION 2
Refer to the exhibit.
An engineer is troubleshooting access point placement issues and suspects that poor placement is causing connectivity issues. When running the show client detail <mac> command, the engineer notices this output. Which option indicates poor access point placement?
- A. excessive number of bytes sent compared to bytes received
- B. high signal-to-noise ratio
- C. excessive number of data retries
- D. low ratio signal strength indicator
- E. duplicate received packets
- F. poor statistics for the last 90 seconds
Answer: CD
NEW QUESTION 3
A WLAN was installed at a high AP density. DTPC is lowering the transmit power of many APs too low. Which change m the DTPC transmit power threshold must be made to allow APs to globally increase
AP transmit power by 3dBm?
- A. from 70 dBm to 73 dBm
- B. from -70 dBm to -73 dBm
- C. from 70 dBm to 67 dBm
- D. from -70 dBm to -67 dBm
Answer: D
NEW QUESTION 4
A Wireless LAN Cisco engineer is troubleshooting 802. 11ac WLAN at customer site Doe to interferences with neighboring 802 11n networks the engineer must determine the current primary secondary channel allocation to enhance the current configuration. Channel 60 has been chosen by the customer as primary 20 MHz channel. Which combination determines the resulting primary 40 MHz and primary 80 MHZ channels?
- A. primary 40 MHz channel 62, primary 80 MM: channel 58
- B. primary 40 MHz channel 54, primary 80 MHz channel 58
- C. primary 40 MHz channel 64, primary 80 MHz channel 60
- D. primary 40 MHz channel 60, primary 80 MHz channel 56
Answer: A
NEW QUESTION 5
Refer to the exhibit.
An engineer is troubleshooting non-802.11 interference and observes the shown output. Which interference signature is depicted?
- A. cordless phone
- B. analog video cameras
- C. microwave oven
- D. FHSS Bluetooth
Answer: B
NEW QUESTION 6
In a cisco OfficeExtend environment, which encryption type n und between the access point and the mass LAW controller?
- A. DTLS
- B. TIS
- C. STIS
- D. OpenSSL
Answer: A
Explanation: DTLS data encryption is enabled automatically for OfficeExtend access points but disabled by default for all other access points. Most access points are deployed in a secure network within a company building, so data encryption is not necessary. In contrast, the traffic between an OfficeExtend access point and the controller travels through an unsecure public network, so data encryption is more important for these access points. When data encryption is enabled, traffic is encrypted at the access point before it is sent to the controller and at the controller before it is sent to the client.
NEW QUESTION 7
A post-deployment wireless survey identifies a roaming issue in the main corridor of a hospital. Which action do you take to mitigate the issue?
- A. Enable RSSI Low Check on the WLC
- B. Disable RRM on the WLC
- C. Change the AP channels in the area.
- D. Enable CleanAir on the WLC
Answer: D
NEW QUESTION 8
An engineer has received an alarm on a wireless LAN controller and is unsure of its meaning. The engineer attempted to ping the wireless LAN controller interfaces. Which troubleshooting methodology does this action demonstrate?
- A. bottom-up
- B. follow the path
- C. shoot from the hip
- D. top-down
- E. divide and conquer
Answer: E
NEW QUESTION 9
Refer to the exhibit.
Which option prevents the AP from completing the DTLS join process?
- A. The SSC is not authorized.
- B. The root CA is missing on the WLC
- C. The WLC has the incorrect date.
- D. An intermediary CA is missing on the WL
Answer: A
NEW QUESTION 10
An engineer is troubleshooting reports from a Cisco 7925 user that is experiencing consistent gaps in audio when roaming from one area of the facility to another. Packet analysis shows that the phone is flapping between two access points due to poor SNR.
Which action fixes this issue?
- A. Add access points to the areas that have a noise floor below -90 dBm.
- B. Adjust the roaming threshold of the WLC to -67 dBm for improved access point performance.
- C. Use coverage hole detection to allow the access points to compensate for the poor roaming.
- D. Redesign the area for sufficient overlap with access points running at reduced power level
Answer: C
NEW QUESTION 11
In a high-density deployment on a customer site with ID 339696181, how do you mitigate the cell size in a large coverage area?
- A. Disable ClientLink on the WLC.
- B. Set a high supported data rate.
- C. Increase the power of the AP.
- D. Set a high mandatory
Answer: C
NEW QUESTION 12
An engineer ran the debug packet logging enable all command, but only 25 packets are shown and none from the client the engineer wants to see.
Which command helps find data that is specific to the client?
- A. debug packet logging enable rx
- B. debug packet logging acl lwapp-ip
- C. debug packet logging enable format
- D. debug packet logging acl ip
Answer: B
NEW QUESTION 13
After you perform a post-installation RF survey for a customer with ID 339696181, you discover that all areas have at least -67 dBm RSSI, 25 dB SNR, and 10 percent cell overlap. The customer, however, reports one-way audio issues on VoWLAN phones.
Which option is a possible cause of the issue?
- A. The cell overlap is too low.
- B. There are coverage black spots.
- C. Non Wi-Fi interference causes a high noise floor.
- D. The RSSI is too hig
Answer: D
NEW QUESTION 14
Which ports require unrestricted port access for CleanAir RF spectrum analysis between the AP and Cisco Spectrum Expert?
- A. UDP 5246 and 5247
- B. UDP 37540 and 37550
- C. TCP 16113 and 16114
- D. TCP 37540 and 37550
- E. TCP 5246 and 5247
- F. UDP 16113and 16114
Answer: D
NEW QUESTION 15
Which modulation, which was introduced in 802.11ac standard, influences end-user experience by providing the highest data rates and throughput?
- A. 256 QAM
- B. QPSK
- C. 16 QAM
- D. 64 QAM
Answer: A
NEW QUESTION 16
You have a single Cisco 5508 WLC with a management IP address of 172.16.24.5/24. You need to register 50 new Cisco AIR-CAP3702I-E-K9. Access Points to the WLC using DHCP option 43. The access points are connected to a switch in VLAN 37, which uses the 172.16.37.0/24 subnet. You have configured the DHCP scope on the switch like this:
Network 172.16.37.0 255.255.255.0
Default Router 172.16.37.1
Option 43 Aseii 172.16.24.5
The access points are failing to join the wireless LAN controller. Which command fixes the issue?
- A. Option 43 Hex F108.CA10.1805
- B. Option 43 Hex F104.AC10.1705
- C. Option 43 Hex F112.CA10.1805
- D. Option 43 Hex F104.AC10.1805
Answer: D
P.S. Certstest now are offering 100% pass ensure 300-370 dumps! All 300-370 exam questions have been updated with correct answers: https://www.certstest.com/dumps/300-370/ (104 New Questions)
