Your success in is our sole target and we develop all our in a way that facilitates the attainment of this target. Not only is our material the best you can find, it is also the most detailed and the most updated. for Cisco 300-370 are written to the highest standards of technical accuracy.
Online Cisco 300-370 free dumps demo Below:
NEW QUESTION 1
Which channel width is the maximum that can be obtained by bonding two 802.11 ac subchannels according to US regulations?
- A. 160 MHz
- B. 120 MHz
- C. 84 MHz
- D. 240 MHz
Answer: A
Explanation: To increase throughput, 802.11ac introduces two new channel widths. All 802.11ac devices are required to support 80 MHz channels, which doubles the size of the spectral channel over 802.11n. It further adds a 160 MHz channel option for even higher speeds. Due to the limitations of finding contiguous 160 MHz spectrum, the standard allows for a 160 MHz channel to be either a single contiguous block or two noncontiguous 80 MHz channels.
NEW QUESTION 2
You detect a coverage hole in some part of the network. After troubleshooting, you find out that the
Cisco 3702i AP is not using all of its transmission power, and hence is not using the 4x4 spatial stream. Which cause of the problem is true?
- A. The upstream switch is not PoE-capable.
- B. The AP antennas have been damaged.
- C. The AP is not 4x4-capable.
- D. The PoE source is not injecting the adequate quantity of powe
Answer: D
NEW QUESTION 3
Refer to the exhibit.
A client reports being unable to log into the wireless network, which uses PEAPv2. Which two issues appear in the output? (Choose two)
- A. The AP has the incorrect RADIUS server address
- B. There is a problem with the client supplicant
- C. The AP has lost IP connectivity to the authentication server
- D. The authentic at ion server is misconfigured on the controller
- E. The EAP client timeout value should be increased
- F. The authentication server is misconfigured in the WLAN
Answer: AC
NEW QUESTION 4
An AP will be deployed to an area where DHCP Option 43 is unavailable and the WLAN engineer is unable to have DNS modifications made to support this AP. Which two actions can enable the AP to join the WLC? (Choose two)
- A. Issue the clear capwap private-config command in the AP console.
- B. Pre-stage or prime the AP on the same Layer 2 VLAN as the WLC.
- C. Issue the capwap ap ip default-gateway WLC IP address command in the AP console.
- D. Issue the capwap ap ip address WLC IP address command in the AP console.
- E. Issue the capwap ap controller ip address WLC IP address command in the AP consol
Answer: AD
NEW QUESTION 5
A wireless engineer is unable to join lightweight access points to the Cisco Wireless Controller. The access points receive ip addresses from a DHCP pool configured on the core switch. Which action must be taken to resolve the issue?
- A. Upgrade the Wireless Controller to a newer IOS release.
- B. Configure option 43 on the DHCP pool.
- C. Configure option 82 on the Wireless controller.
- D. Change the management ip address on the Wireless Controlle
Answer: C
NEW QUESTION 6
A company consists of two adjacent buildings, each with its own Cisco 5508 Wireless Controller with APs joined to the controller in the building. The two controllers are configured identically except for interface IP addresses. Only one SSID is being used in both buildings. The clients in building A are not experiencing any connectivity issues, but (he clients in building B report poor connections An
engineer performs a site survey and finds co-channel interference, yet discovers mac Transmit Power Control was never performed on the APs and that Radio Resource Management is not functioning like it does in building A Furthermore, the controllers are in the same RF group and controller A is elected RF leader Which action will improve client connections in building B?
- A. Ensure WMM is enabled on the SSID.
- B. Manually select controller B as RF group leader.
- C. Configure controller B to be in a separate RF group.
- D. Doable the low data rates on the a radio and the b/g radio in building
Answer: C
NEW QUESTION 7
An engineer is troubleshooting non-802 11 interference and observes this output. Which type of interference signatures can be identified?
Refer to the exhibit.
- A. one frequency hopping Bluetooth
- B. two healthy CCK and one malformed OFDM
- C. three broadband jammers
- D. two strong microwave ovens and one moderate
Answer: B
NEW QUESTION 8
Refer to the exhibits. An engineer is troubleshooting connectivity issues on the guest network.
Which cause of the issue is true?
- A. The spanning-tree portfast trunk command must be removed.
- B. The switchport mode must be configured as access.
- C. The interface group has incorrect mappings.
- D. The trunk port does not have the correct VLANs allowe
Answer: D
NEW QUESTION 9
A network engineer is troubleshooting why EAP authentication with a client is failing. Which two commands should be used to resolve the issue? (Choose two)
- A. debug dot1x notifications enable
- B. debug dot1x events enable
- C. debug arp
- D. debug aaa detail enable
- E. debug aaa events detail enable
Answer: BE
NEW QUESTION 10
A client is failing EAP authentication and a debug shows that the server is sending an Access-Reject message. Which action must you take to resolve authentication?
- A. Verify that the Validate server certificate on the client is disabled.
- B. Verify that the client certificates are from the proper CA and server certificate.
- C. Verify that the client server certificate has the proper Windows OlDs.
- D. Verify that the user account is the same in the client certificate.
- E. Verify that the user is using the same password that is on the server
Answer: B
NEW QUESTION 11
Refer to the exhibit. Which configuration must be addresses to correct this issue?
- A. self-signed certificate
- B. DHCP Option 43
- C. Network Time Protocol
- D. AP authorization list
Answer: A
NEW QUESTION 12
Which statement about the process of rogue containment performed on a rogue AP and rogue clients is true?
- A. Trusted clients are configured to ignore the rogue AP so that only the rogue clients can connect.
- B. An RF jammer is used to prevent the rogue AP from transmitting.
- C. An authorized AP spoofs de-authentication packets that have the spoofed source address of the rogue AP.
- D. A trusted AP is configured to mimic the rogue AP and to prevent clients from associating to the rogue AP.
Answer: C
NEW QUESTION 13
A Cisco WLC v7.0 is not seeing an AP join. Which starting prefix debug command can help determine a combination of discovery/join and DHCP process status?
- A. debug capwap events - from Cisco WLC
- B. debug capwap events - from the AP
- C. debug ip udp - from Cisco WLC
- D. debug ip udp - from the AP
Answer: D
NEW QUESTION 14
An engineer has discovered that a number of new access points are failing to join the wireless controller
module that has been recently enabled on a switch stack of three Cisco Catalyst 3850 switches running
3.02.03 SE version of Cisco IOS-XE. All cables have been verified and all access point switch port configurations are identical.
Which options is the likely root cause of the issue?
- A. Stacked Cisco Catalyst 3850 switches only support 100 CAPWAP termination licences.
- B. Cisco IOS-XE version 3.02.03 SE supports only access points on the master switch.
- C. The EULA has not been accepted on the switch wireless controller module.
- D. When stacked, the Cisco Catalyst 3850 cannot use the wireless controller modul
Answer: D
NEW QUESTION 15
An engineer is concerned about rogue-on-wire and wants to enable port security. Which guideline must the engineer follow?
- A. Configure Switched Port Analyzer destination ports as secure.
- B. Use 802 1x with port security to prevent MAC spoofing.
- C. Enable port security on dynamic access ports.
- D. Employ static MAC address configuration for APs with port securit
Answer: A
NEW QUESTION 16
You are debugging a WGB client. Which description of the client is true?
- A. disconnected from the wired device
- B. triggered to reauthenticate
- C. disconnected from the authentication server
- D. triggered to roam
Answer: D
P.S. Certstest now are offering 100% pass ensure 300-370 dumps! All 300-370 exam questions have been updated with correct answers: https://www.certstest.com/dumps/300-370/ (104 New Questions)
