Master the H12-811_V1.0 HCIA-Datacom V1.0 content and be ready for exam day success quickly with this Certleader H12-811_V1.0 free exam questions. We guarantee it!We make it a reality and give you real H12-811_V1.0 questions in our HUAWEI H12-811_V1.0 braindumps.Latest 100% VALID HUAWEI H12-811_V1.0 Exam Questions Dumps at below page. You can use our HUAWEI H12-811_V1.0 braindumps and pass your exam.
HUAWEI H12-811_V1.0 Free Dumps Questions Online, Read and Test Now.
NEW QUESTION 1
In the campus network, the reliability of the network can be improved by using link aggregation and stacking technology. ()
- A. True
- B. False
Answer: A
NEW QUESTION 2
ifoneLength/Type = 0X8100 taught by the Ethernet data, which of the following is correct? ()
- A. There must be a UDP header in the upper layer of this data frame
- B. The upper layer of this data frame must existIP header
- C. There must be a TCP header in the upper layer of this data frame
Answer: C
NEW QUESTION 3
The network structure and OSPF partition are shown in the figure. Except for RTA in the figure, the routers RTB, RTC and RTD are all ABR routers. ()(True or False)
- A. True
- B. False
Answer: B
NEW QUESTION 4
An ACL rule is as follows: Which of the following IP addresses can be matched by permit rules? () rule5per mit ip source10.0.2.00.0.254.255
- A. 10.0.6.7
- B. 10.0.4.5
- C. 10.0.5.6
- D. 10.0.2.I
Answer: C
NEW QUESTION 5
In order to realize the network layer function on the VLANIIF interface, need to be configured on the VLANIF interface? ()*
- A. Subnet mask
- B. MAC.Address
- C. IP prefix
- D. IP address
Answer: AD
NEW QUESTION 6
Which of the following attributes cannot be used as a measure of CoThe parameter of st? ()*
- A. bandwidth
- B. Sysname
- C. Time delay
- D. Hop count
Answer: BC
NEW QUESTION 7
Which of the following features does the default VLAN in the Layer 2 Ethernet switch have? ()*
- A. The default VLAN cannot be deleted manually
- B. By default, all ports of the switch are member ports of the default VLAN
- C. A default VLAN must be created before it can be assigned a port
- D. The P address configured on the switch will only be applied to the member ports of the default VLAN
Answer: AB
NEW QUESTION 8
Which of the following statements about IPv6 anycast addresses are correct? ()*
- A. Anycast address and unicast address use the same address space
- B. Provide additional functions for the service
- C. The packet whose destination address is the anycast address will be sent to the nearest network interface in the sense of routing
- D. Realize service load sharing
Answer: ABC
NEW QUESTION 9
On an interface that uses PPP as the data link layer protocol, can you configure a static route by specifying the next hop address or outbound interface? ()
- A. True
- B. False
Answer: A
NEW QUESTION 10
The network shown in the figure below. From a security perspective, router A refuses to receive OSPF packets and ICMP packets received from interface G0/0/1. Which of the following commands can achieve this requirement? () (Multiple Choice Questions)
- A. acl number 3000 Rule 5 deny 89 Rule 10 deny icmp#Interface GigabitEthernet0/0/1Traffic-filter inbound acl 3000#
- B. acl number 3000 Rule 5 deny 89Rule 10 deny 1#Interface GigabitEtherneto/0/1Traffic-filter inbound acl 3000#
- C. acl number 2000 Rule 5 deny 89Rule 10 deny 1#Interface GigabitEthernet0/0/1Traffic-filtet inbound acl 2000#
- D. acl number 3000 Rule 5 deny ospf Rule 10 deny icmp#Interface GigabitEthernet0/0/1Traffic-filtet inbound acl 3000#
Answer: ABD
NEW QUESTION 11
Which of the following commands can be used to view the CPU usage of the router? ()
- A. display cpu-state
- B. display interface
- C. display memory
- D. display cpu-usage
Answer: D
NEW QUESTION 12
By default, the bridge priority of Huawei switches is 32768.
- A. True
- B. False
Answer: A
NEW QUESTION 13
The link aggregation interface can only be used as a Layer 2 interface (C)
- A. True
- B. False
Answer: A
NEW QUESTION 14
Regarding the corresponding relationship between the access control list number and type, the following description is correct ()
- A. The number range of the second-level access control list is 4000-4999
- B. The number range of the interface-based access control list is1000-2000
- C. Advanced access control list number range is 3000-4000
Answer: B
NEW QUESTION 15
As shown in the figure, when the switch needs to forward frames with the destination mac address of 5489-98ec-f011, which of the following descriptions is correct? () (Single-choice question)
- A. The switch will send a message that the destination is unreachable to the source device
- B. The switch did not find a matching entry in the mac address tabl
- C. So the frame will be discarded
- D. The switch needs to send a request to discover the device with the mac address of 5489-98ec-f011
- E. The switch will be All ports outside flood the frame
Answer: D
NEW QUESTION 16
The Huawei tracert diagnostic attack is used to track the forwarding path of data ()
- A. True
- B. False
Answer: A
NEW QUESTION 17
As shown in the figure, two hosts realize communication between TAs through single-arm routing. When the G0/0/1.2 sub-interface of RTA. receives the data frame sent by host B. to host A., RTA. will execute which of the following Operation? ()
- A. RT
- B. First delete VLAN tag 20, then add VLAN tag 10, and then send it out via G0/0/1.1 interface
- C. RT
- D. Forward the data frame directly through the G0/0/1.1 sub-interface
- E. RT
- F. The data frame will be discarded
- G. RT
- H. After deleting VLAN tag 20, it will be sent out by G0/0/1.1 interface
Answer: A
NEW QUESTION 18
After FIT AP obtains AC.'s IP address, what is the first operation to perform? ()
- A. Download the configuration file
- B. Establish a CAPWAP tunnel
- C. Request configuration file
Answer: C
NEW QUESTION 19
NAPT allows multiple private IP addresses to be mapped to the same public P address through different port numbers. The following description of the port number in NAPT is correct ().
- A. The correspondence between port numbers and private addresses must be manually configured
- B. No need to do any configuration about port number
- C. Only need to configure the range of port numbers
- D. Need to use ACL to assign port numbers
Answer: B
NEW QUESTION 20
The routing table is generated by*
- A. Direct connection
- B. Static
- C. OSPF
- D. ISIS
Answer: ABCD
NEW QUESTION 21
......
P.S. Easily pass H12-811_V1.0 Exam with 730 Q&As Allfreedumps.com Dumps & pdf Version, Welcome to Download the Newest Allfreedumps.com H12-811_V1.0 Dumps: https://www.allfreedumps.com/H12-811_V1.0-dumps.html (730 New Questions)
