What Top Quality H12-811_V1.0 Preparation Labs Is

Proper study guides for Leading HUAWEI HCIA-Datacom V1.0 certified begins with HUAWEI H12-811_V1.0 preparation products which designed to deliver the Downloadable H12-811_V1.0 questions by making you pass the H12-811_V1.0 test at your first time. Try the free H12-811_V1.0 demo right now.

Online HUAWEI H12-811_V1.0 free dumps demo Below:

NEW QUESTION 1

What kind of packets does the OSPF protocol use to discover and maintain neighbor relationships? ()

  • A. HELLO
  • B. LSU
  • C. DD

Answer: B

NEW QUESTION 2

What is wrong about the ARP message? ()

  • A. ARP packets cannot be forwarded to other broadcast domains
  • B. ARP reply message is sent by unicast party
  • C. ARP request message is sent by broadcast
  • D. Any link layer protocol requires ARP protocol to assist in obtaining data link layer identification

Answer: D

NEW QUESTION 3

The IPv6 protocol uses NS and NA. packets for duplicate address detection ().

  • A. True
  • B. False

Answer: A

NEW QUESTION 4

When using the FTP protocol to upgrade the router software, the transmission mode should be selected ()

  • A. Binary mode
  • B. Byte mode
  • C. Text mode
  • D. Stream byte mode

Answer: A

NEW QUESTION 5

The configuration of the country code will affect the actual frequency used for transmission and the maximum transmission power ()

  • A. True
  • B. False

Answer: A

NEW QUESTION 6

The administrator wants to allocate a Hundred P address on the G0/0/0 interface of the router. Which of the following addresses is correct? ()

  • A. 192.168.10.112/30
  • B. 237.6.1.2/24
  • C. 127.3.1.4/28
  • D. 145.4.2.55/26

Answer: D

NEW QUESTION 7

In the OSPF protocol, which of the following descriptions of DR is correct? ()

  • A. If the priority values of the two routers are equal, the router with the larger Router ID is selected as the DR
  • B. By default, all routers in this broadcast network will participate in the DR election
  • C. If the priority values of the two routers are different, the router with the lower priority is selected as the DR
  • D. DThe adjacency relationship should also be established between R and BDR

Answer: D

NEW QUESTION 8

Trunk ports can allow multiple VLANs to pass, including VLAN4096. ()

  • A. True
  • B. False

Answer: B

NEW QUESTION 9

On Huawei equipment, if AAA authentication is used for authorization, when the remote server does not respond, authorization can be performed from the network equipment side ()

  • A. True
  • B. False

Answer: A

NEW QUESTION 10

Which of the following messages does the AP use to request the software version from AC.? ()

  • A. VRP System Request
  • B. Software Request
  • C. Image DatA.Request
  • D. Image package Request

Answer: C

NEW QUESTION 11

There are multiple route entries to the same destination network in the routing table. These routes are called? ()

  • A. Suboptimal routing
  • B. Multipath routing
  • C. Default route
  • D. Equal cost routing

Answer: D

NEW QUESTION 12

Protocol Priority Switch A. and Switch B. adopt LACP mode link aggregation, and all interfaces join the link aggregation group. At the same time, set the maximum number of active ports to 3. Then which port of switch A is not an active port? ()

  • A. G0/0/1
  • B. G0/0/3
  • C. G0/0/0

Answer: C

NEW QUESTION 13

When a company's network management needs to plan the network, the data packets that allow PC1 to access PC2 go through the G0/0/0 port (G0/0/2 on the picture). The data packet that PC2 accesses to PC1 goes from port G0/0/4 (G0/0/0 in the picture). () (Single-choice question)
H12-811_V1.0 dumps exhibit

  • A. 10.0.12.5255.255.255.25511.0.12.6#10.0.12.1255.255.255.25511.0.12.1
  • B. 10.0.12.5255.255.255.25511.0.12.210.* 0.12.1255.255.255.25511.0.12.5
  • C. 0.0.0.00.0.0.00#11.0.12.6#11.0.12.1
  • D. 0.0.0.0#0.0.0.0#11.0.12.2#11.0.12.5

Answer: B

NEW QUESTION 14

If the Proto of a certain route information in the routing table is OSPF, the priority of this route must be 10. ()

  • A. True
  • B. False

Answer: B

NEW QUESTION 15

What are the user authentication methods that can be deployed in wlan? ()

  • A. Portal authentication
  • B. MA
  • C. Authentication
  • D. Radius certification
  • E. 802.1X authentication

Answer: ABD

NEW QUESTION 16

Which of the following port states does the RSTP protocol include? ()*

  • A. Learning
  • B. Discarding
  • C. Listening
  • D. Forwarding

Answer: ABD

NEW QUESTION 17

Regarding the IPv6 address 2031:0000:720C:0000:0000:09E0:839A:130B, which of the following abbreviations are correct? ()

  • A. 2031:0:720C:-9E0:839A:130B
  • B. 2031:0:720C:0:0:9E0:839A:130B
  • C. 2031:720C:9E0:839A:130B

Answer: B

NEW QUESTION 18

What is the full name of the general routing platform VRP? ()

  • A. Versatile Redundancy Platform
  • B. Versatile Routing Protocol
  • C. Versatile Routing Platform
  • D. Virtual Routing Platform

Answer: C

NEW QUESTION 19

When using the SNMPv1 protocol to manage network devices, which of the following commands is used by the network management system to complete the configuration of the network devices? ()

  • A. Response
  • B. Set Request
  • C. Get-Request

Answer: C

NEW QUESTION 20

The priority of the LACP protocol is shown in the figure. Switch A and Switch B adopt LACP mode link aggregation, and all interfaces are added to the link aggregation group. At the same time, set the maximum number of active ports to 3. Then which port of switch A is not an active port ? () (Single-choice question)
H12-811_V1.0 dumps exhibit

  • A. G0/0/0
  • B. G0/0/1
  • C. G0/0/2
  • D. G0/0/3

Answer: D

NEW QUESTION 21
......

P.S. Easily pass H12-811_V1.0 Exam with 730 Q&As Certshared Dumps & pdf Version, Welcome to Download the Newest Certshared H12-811_V1.0 Dumps: https://www.certshared.com/exam/H12-811_V1.0/ (730 New Questions)