Your success in Cisco 300 101 exam is our sole target and we develop all our 300 101 exam braindumps in a way that facilitates the attainment of this target. Not only is our ccnp routing and switching route 300 101 complete video course study material the best you can find, it is also the most detailed and the most updated. cisco 300 101 Practice Exams for Cisco CCDP ccnp routing and switching route 300 101 official cert guide are written to the highest standards of technical accuracy.
♥♥ 2021 NEW RECOMMEND ♥♥
Free VCE & PDF File for Cisco 300-101 Real Exam (Full Version!)
★ Pass on Your First TRY ★ 100% Money Back Guarantee ★ Realistic Practice Exam Questions
Free Instant Download NEW 300-101 Exam Dumps (PDF & VCE):
Available on:
http://www.surepassexam.com/300-101-exam-dumps.html
P.S. Verified 300-101 item pool are available on Google Drive, GET MORE: https://drive.google.com/open?id=1rlPNNoD0ZdgZsqoRN-j_tpudN825BWM5
New Cisco 300-101 Exam Dumps Collection (Question 5 - Question 14)
Question No: 5
Which option is one way to mitigate symmetric routing on an active/active firewall setup for TCP-based connections?
A. performing packet captures
B. disabling asr-group commands on interfaces that are likely to receive asymetric traffic
C. replacing them with redundant routers and allowing load balancing
D. disabling stateful TCP checks
Answer: D
Question No: 6
Which IP SLA operation requires Cisco endpoints?
A. UDP Jitter for VoIP
B. ICMP Path Echo
C. ICMP Echo
D. UDP Jitter
Answer: A
Explanation:
UDP Jitter Operation
With the addition of real-time traffic (ie: VoIP), the focus shifts not just in the reliability of the network, but also on the delays involved in transmitting the data. Real-time traffic is delay sensitive. For Voice data, packet loss is manageable to some extent, but frequent losses impair communication between endpoints. The UDP jitter operation is the most popular operation because the user can obtain packet loss, jitter and latency from one operation. This also includes unidirectional measurements as well.
The Jitter operation is designed to measure the delay, delay variance and packet loss in IP networks by generating active UDP traffic. It sends N packets, each of size S, from source router to a target router (which requires Cisco IOS IP SLAs responder enabled) each T milliseconds apart. All these parameters are user configurable.
http://www.cisco.com/en/US/technologies/tk648/tk362/tk920/technologies_white_paper09186a00802d5efe.html
Question No: 7
The company network is in the process of migrating the IP address scheme to use IPv6. Which of the following address types are associated with IPv6? (Select three)
A. Unicast
B. Private
C. Broadcast
D. Public
E. Multicast
F. Anycast
Answer: A,E,F
Question No: 8
An engineer is using a network sniffer to troubleshoot DHCPv6 between a router and hosts on the LAN with the following configuration:
Interface Ethernet0
Ipv6 dhcp server DHCPSERVERPOOL rapid-commit
!
Which two DHCPv6 messages will appear in the sniffer logs?
A. reply
B. request
C. advertise
D. acknowledge
E. solicit
F. accept
Answer: A,E
Question No: 9
CORRECT TEXTA network engineer enables OSPF on a Frame Relay WAN connecton to various remote stes, but no OSPF adiacencies come up Which two actions are possible solutions for thisissue? (Choose Two)
A Change the network type to point-to-murpont under WAN interface
B. Enable virtual Inks
C. Change the networktype to nonbroadcast mutpoint access
D. Configure the neighbor command under OSPF process for each remote ste
E. Ensure that the OSPF process number matches among all remote stes
Answer: A, D
Question No: 10
Which statement is true concerning 6to4 tunneling?
A. IPv4 traffic is encapsulated with an IPv6 header.
B. The edge routers can use any locally configured IPv6 address.
C. Hosts and routers inside a 6to4 site will need a special code.
D. An edge router must use IPv6 address of 2002::/16 in its prefix.
Answer: D
Explanation:
6to4 tunnels use IPv6 addresses that concatenate 2002::/16 with the 32-bit IPv4 address of the edge router, creating a 48-bit prefix.
Question No: 11
A network engineer applies the command ip tcp adjust-mss <bytes> under interface configuration mode. What is the result?
A. The probability of SYN packet truncation is increased.
B. The UDP session is inversely affected.
C. The probability of dropped or segmented TCP packets is decreased.
D. The optimum MTU value for the interface is set.
Answer: C
Question No: 12
What are three IPv6 transition mechanisms? (Choose three)
A. 6to4 tunneling
B. VPN tunneling
C. GRE tunneling
D. ISATAP tunneling
E. PPP tunneling
F. Teredo tunneling
Answer: A,D,F
Explanation:
Below is a summary of IPv6 transition technologies:
6 to 4 tunneling: This mechanism allows IPv6 sites to communicate with each other over the IPv4 network without explicit tunnel setup. The main advantage of this technology is that it requires no end-node reconfiguration and minimal router configuration but it is not intended as a permanent solution.
ISATAP tunneling (Intra-Site Automatic Tunnel Addressing Protocol): is a mechanism for transmitting IPv6 packets over IPv4 network. The word u201cautomaticu201d means that once an ISATAP server/router has been set up, only the clients must be configured to connect to it. Teredo tunneling: This mechanism tunnels IPv6 datagrams within IPv4 UDP datagrams, allowing private IPv4 address and IPv4 NAT traversal to be used.
In fact, GRE tunneling is also a IPv6 transition mechanism but is not mentioned in BSCI so we shouldnu2021t choose it (there are 4 types of IPv6 transition mechanisms mentioned in BSCI; they are manual, 6-to-4, Teredo and ISATAP).
Question No: 13
Which PPP authentication method sends authentication information in cleartext?
A. MS CHAP
B. CDPCP
C. CHAP
D. PAP
Answer: D
Question No: 14
Refer to the exhibit.
Which statement about the configuration is true?
A. This configuration is incorrect because the MTU must match the ppp-max-payload that is defined.
B. This configuration is incorrect because the dialer interface number must be the same as the dialer pool number.
C. This configuration is missing an IP address on the dialer interface.
D. This configuration represents a complete PPPoE client configuration on an Ethernet connection.
Answer: D
P.S. Easily pass 300-101 Exam with Examcollectionplus Verified Dumps & pdf vce, Try Free: https://www.examcollectionplus.net/vce-300-101/ (745 New Questions)
