teenager post 101-200 [May 2016]

Refined of 200-101 book materials and rapidshare for Cisco certification for examinee, Real Success Guaranteed with Updated 200-101 pdf dumps vce Materials. 100% PASS Interconnecting Cisco Networking Devices Part 2 (ICND2) exam Today!

2016 May 200-101 Study Guide Questions:

Q21. At which layer of the OSI model is RSTP used to prevent loops? 

A. physical 

B. data link 

C. network 

D. transport 

Answer: B 


Q22. Which two statements about using the CHAP authentication mechanism in a PPP link are true? (Choose two.) 

A. CHAP uses a two-way handshake. 

B. CHAP uses a three-way handshake. 

C. CHAP authentication periodically occurs after link establishment. 

D. CHAP authentication passwords are sent in plaintext. 

E. CHAP authentication is performed only upon link establishment. 

F. CHAP has no protection from playback attacks. 

Answer: BC 


Q23. The following configuration is applied to a Layer 2 Switch: 

interface fastethernet 0/4 

switchport mode access 

switchport port-security 

switchport port-security mac-address 0000.1111.1111 

switchport port-security maximum 2 

swithcport port-security 

What is the result of the above configuration being applied to the switch? 

A. A host with a mac address of 0000.1111.1111 and up to two other hosts can connect to FastEthernet 0/4 simultaneously 

B. A host with a mac address of 0000.1111.1111 and one other host can connect to Fast Ethernet 0/4 simultaneously 

C. Violating addresses are dropped and no record of the violation is kept 

D. The switch can send an SNMP message to the network management station 

E. The port is effectively shutdown 

Answer: BD 


200-101  book

Refresh free printable number grid 101-200:

Q24. Refer to the exhibit. 


How will the router handle a packet destined for 192.0.2.156? 

A. The router will drop the packet. 

B. The router will return the packet to its source. 

C. The router will forward the packet via Serial2. 

D. The router will forward the packet via either Serial0 or Serial1. 

Answer: C 


Q25. Which two are advantages of static routing when compared to dynamic routing? (Choose two.) 

A. Configuration complexity decreases as network size increases. 

B. Security increases because only the network administrator may change the routing table. 

C. Route summarization is computed automatically by the router. 

D. Routing tables adapt automatically to topology changes. 

E. An efficient algorithm is used to build routing tables, using automatic updates. 

F. Routing updates are automatically sent to neighbors. 

G. Routing traffic load is reduced when used in stub network links. 

Answer: BG 


Q26. Which PPP subprotocol negotiates authentication options? 

A. NCP 

B. ISDN 

C. SLIP 

D. LCP 

E. DLCI 

Answer: D 


200-101  book

100% Guarantee triple j 200-101:

Q27. Refer to the exhibit. **Exhibit Missing**

A technician pastes the configurations in the exhibit into the two new routers shown. Otherwise, the routers are configured with their default configurations. A ping from Host1 to Host2 fails, but the technician is able to ping the S0/0 interface of R2 from Host1. The configurations of the hosts have been verified as correct. What is the cause of the problem? 

A. The serial cable on R1 needs to be replaced. 

B. The interfaces on R2 are not configured properly. 

C. R1 has no route to the 192.168.1.128 network. 

D. The IP addressing scheme has overlapping subnetworks. 

E. The ip subnet-zero command must be configured on both routers. 

Answer: C 


Q28. Refer to the exhibit. 


What information about the interfaces on the Main_Campus router is true? 

A. The LAN interfaces are configured on different subnets. 

B. Interface FastEthernet 0/0 is configured as a trunk. 

C. The Layer 2 protocol of interface Serial 0/1 is NOT operational. 

D. The router is a modular router with five FastEthernet interfaces. 

E. Interface FastEthernet 0/0 is administratively deactivated. 

Answer: B 


Q29. What is the advantage of using a multipoint interface instead of point-to-point subinterfaces when configuring a Frame Relay hub in a hub-and-spoke topology? 

A. It avoids split-horizon issues with distance vector routing protocols. 

B. IP addresses can be conserved if VLSM is not being used for subnetting. 

C. A multipoint interface offers greater security compared to point-to-point subinterface configurations. 

D. The multiple IP network addresses required for a multipoint interface provide greater addressing flexibility over point-to-point configurations. 

Answer: B 


Q30. The internetwork infrastructure of company XYZ consists of a single OSPF area as shown in the graphic. There is concern that a lack of router resources is impeding internetwork performance. As part of examining the router resources, the OSPF DRs need to be known. All the router OSPF priorities are at the default and the router IDs are shown with each router. 


Which routers are likely to have been elected as DR? (Choose two.) 

A. Corp-1 

B. Corp-2 

C. Corp-3 

D. Corp-4 

E. Branch-1 

F. Branch-2 

Answer: DF 



see more 200-101 dumps