1. Hassle-free and productive 2. Perfect supplier for busy workers Three or more. Interactive testing engine 4. Printable Pdf forms Your five. Online technical assistance in case of difficulty Some. Instant download gain access to after acquire 7. Simulates real exam environment 8. Self-paced review course 9. Regularly updated JN0-533 exam questions and answers
2021 Nov JN0-533 free question
Q11. You want to centralize the logging for all your ScreenOS devices and you must be able to synchronize the log. Which two actions would you perform to accomplish this? (Choose two.)
A. Enable logging to the console.
B. Enable logging to syslog.
C. Enable NTP and set to UTC/GMT time.
D. Enable logging to the USB.
Q12. Click the Exhibit button.
Referring to the exhibit, what does the log show?
A. The device is using VIP.
B. The device is using DIP ID 4.
C. The device is using source NAT.
D. The device is using destination NAT.
Q13. Which two statements are true about VPN Monitor on a ScreenOS device? (Choose two.)
A. With a route-based VPN failure, VPN Monitor marks the tunnel interface status as down.
B. With a policy-based VPN failure, VPN Monitor marks the tunnel interface status as down.
C. VPN Monitor uses UDP to detect a VPN connection failure.
D. VPN Monitor uses ICMP to detect a VPN connection failure.
Q14. How is the maximum bandwidth pool allocated when all policies share the same priority?
A. first come first served
B. round robin
C. packet DSCP value
D. policy order number
Q15. You want to ensure that the ScreenOS device sends alert data to notify the security operation center. Which three log destinations would you set to accomplish your objective? (Choose three.)
Improve JN0-533 free draindumps:
Q16. You must translate a range of public IP addresses to a range of internal IP addresses.
Which two mechanisms would you use to accomplish your objective? (Choose two.)
A. MIP using masks
B. VIP using masks
C. policy-based NAT-dst
D. policy-based NAT-src
Q17. Which dynamic routing protocol does IPv6 use?
Q18. Click the Exhibit button.
In the network shown in the exhibit, you have been asked to enable users in the Untrust zone to contact Server1 on TCP port 80 using IP address 18.104.22.168. You also need to allow Server1 to make connections to hosts in the Untrust zone. When Server1 makes connections to the Untrust zone, the source address of its traffic should be translated to 22.214.171.124.
What would you use to configure this behavior?
Q19. Which NAT has bidirectional translation by default?
Q20. You want to set up a last resort route and prevent route lookups in either the source-based routing table or the destination-based routing table.
What should you do?
A. Disable SIBR and create a default route in the trust-vr table using the null interface as the outgoing interface with a higher metric than other routes.
B. Disable SIBR and create a default route in the trust-vr table using the null interface as the outgoing interface with a lower metric than other routes.
C. Enable SIBR and create a default route in the SIBR table using the null interface as the outgoing interface with a higher metric than other routes.
D. Enable SIBR and create a default route in the SIBR table using the null interface as the outgoing interface with a lower metric than other routes.
see more JN0-533 dumps